Microwave power is seen as a promising alternative to conventional methods for drying freshly harvested grains to safe storage moisture levels. In an attempt to elaborate a continuous flow microwave dryer, the optimum operating characteristics of a prototype microwave antenna were investigated during a low power microwave drying simulation with corn at three different moisture content levels (15%, 23% and 30% w.b.). The antenna consisted of a slotted waveguide with the orientation and width of the slots being the main points of investigation. / The optimum angle of the slots with respect to the direction of propagation of the travelling wave was found to be in the neighbourhood of 55° at all moisture contents. Slots 13 mm wide gave better results than the 6 mm ones which are often suggested in literature.
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:QMM.20872 |
| Date | January 1998 |
| Creators | St-Denis, Eric. |
| Contributors | Raghavan, G. S. V. (advisor) |
| Publisher | McGill University |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Format | application/pdf |
| Coverage | Master of Science (Department of Agricultural and Biosystems Engineering.) |
| Rights | All items in eScholarship@McGill are protected by copyright with all rights reserved unless otherwise indicated. |
| Relation | alephsysno: 001609976, proquestno: MQ44288, Theses scanned by UMI/ProQuest. |
Page generated in 0.0021 seconds