Return to search

SENSITIVITY OF TERRAIN ATTRIBUTES, WATERSHED ATTRIBUTES, AND SWAT DERIVED HYDROLOGICAL OUTPUTS TO LIDAR DERIVED DEM UNCERTAINTY

This research analyzes the sensitivity of watershed attributes, and hydrological outputs to LiDAR derived DEM uncertainty introduced through spatial resolution, and LiDAR measurement errors. Sensitivity of watershed attributes to spatial resolution was determined through a scaling analysis at three sites; Mosquito Creek, Scotty Creek and Thomas Brook, with DEMs ranging from 1 to 50 m. Results at Scotty Creek showed the highest sensitivity of watershed area to spatial resolution, due to subtle changes in elevation which were below DEM uncertainty. Validation of the stream length at Thomas Brook showed discrepancies of 3.7 to 24.1% for the 1 to 50 m DEMs, compared to independent field observations. Sensitivity of SWAT derived hydrological outputs to DEM spatial resolution were determined through a scaling analysis of DEMs (1 - 50 m) at Thomas Brook watershed, over a five year simulation period. Results indicated monthly water yield was insensitive to DEM resolution, unless a change in area was also present. Sediment yield from the 50 m DEM showed a 24% reduction compared to the 1 m DEM. The 5 - 50 m DEMs also showed a reduction in channel deposition of 45 - 90 t, compared to the 1 m DEM.
Sensitivity of terrain attributes, watershed attributes and hydrological outputs to LiDAR measurement errors were determined at the Thomas Brook watershed through the propagation of LiDAR sensor measurement errors with Monte Carlo simulations. Results showed that the uncertainty in the DEM, slope, and aspect were below 0.06 cm, 1.5° and 24.1° in 97.5% of grid cells, respectively. Watershed area and stream length resulted in relative standard deviations of <1% and 1.5%, respectively. However, sensitivity of watershed area increased in regions with elevation changes below DEM uncertainty and stream length uncertainty increased with decreasing stream length. SWAT simulated flow and sediment showed minor sensitivity to LiDAR measurement error in high flow months, and increased as flow decreased. Simulated sediment showed higher sensitivity to LiDAR measurement errors than flow, due to changes in the HRU slope class, which can shift the dominant HRU (Hydrological Response Unit) if a minimum HRU threshold area is implemented.

Identiferoai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:NSHD.ca#10222/38534
Date30 September 2013
CreatorsGoulden, Tristan
Source SetsLibrary and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada
LanguageEnglish
Detected LanguageEnglish

Page generated in 0.0019 seconds