Diploma thesis deals with optimization of technological process casting a die cast, which is part of vacuum pump. The die cast is made from alloy AlSi9Cu3(Fe) in foundry KOVOLIT, a. s. There is a problem with inner defects at this cast. Solution of this thesis is to suggest suitable actions to minimize of incidence the defects in the cast. According to analysis of the defects in the cast these defects were classified as combination of shrinkages and gas holes. According to analysis causes of the defects are high temperature of die mould and closed air in die mould. As a result suitable actions were suggested – a change of the die mould tempering and a design adjustment of the cast. In case of implementing a new die mould in the manufacture a new gating system was designed. Suitability of the new gating system was assessed according to simulation of filling die cavity.
| Identifer | oai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:231431 |
| Date | January 2014 |
| Creators | Krňávek, Štěpán |
| Contributors | Kolmačka, Marek, Roučka, Jaromír |
| Publisher | Vysoké učení technické v Brně. Fakulta strojního inženýrství |
| Source Sets | Czech ETDs |
| Language | Czech |
| Detected Language | English |
| Type | info:eu-repo/semantics/masterThesis |
| Rights | info:eu-repo/semantics/restrictedAccess |
Page generated in 0.0024 seconds