Return to search

Modeling of Ion Injection in Oil-Pressboard Insulation Systems

To make a High Voltage Direct Current (HVDC) transmission more energy efficient, the voltage of the system has to be increased. To allow for that the components of the system must be constructed to handle the increases AC and DC stresses that this leads to. One key component in such a transmission is the HVDC converter transformer. The insulation system of the transformer usually consists of oil and oil-impregnated pressboard. Modeling of the electric DC field in the insulation system is currently done with the ion drift diffusion model, which takes into account the transport and generation of charges in the oil and the pressboard. The model is however lacking a description of how charges are being injected from the electrodes and the oil-pressboard interfaces. The task of this thesis work was to develop and implement a model for this which improves the result of the ion drift diffusion model. A theoretical study of ion injection was first carried out and proceeding from this, a model for the ion injection was formulated. By using experimental data from 5 different test geometries, the injection model could be validated and appropriate parameter values of the model could be determined. By using COMSOL Multiphysics®, the ion drift diffusion model with the injection model could be simulated for the different test geometries. The ion injection gave a substantial improvement of the ion drift diffusion model. The positive injection from electrodes into oil was found to be in the range 0.3-0.6 while the negative injection was 0.3 lower. Determination of the parameters for the injection from oil-pressboard interfaces proved to be difficult, but setting the parameters in the range 0.01-1 allowed for a good agreement with the experimental data. Here, a fit could be obtained for multiple assumptions about the set of active injection parameters. Finally it is recommended that the investigation of the ion injection continues in order to further improve the model and more accurately determine the parameters of it. Suggestions on how this work could be carried out are given in the end.

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:uu-177600
Date January 2012
CreatorsSonehag, Christian
PublisherUppsala universitet, Fasta tillstĂĄndets elektronik
Source SetsDiVA Archive at Upsalla University
LanguageEnglish
Detected LanguageEnglish
TypeStudent thesis, info:eu-repo/semantics/bachelorThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess
RelationUPTEC F, 1401-5757 ; 12022

Page generated in 0.0022 seconds