Return to search

Improving Doping and Minority Carrier Lifetime of CdTe/CdS Solar Cells by in-situ Control of CdTe Stoichiometry

Cadmium Telluride (CdTe) is a leading thin film photovoltaic (PV) material due to its near ideal bandgap of 1.45 eV and its high optical absorption coefficient. Advancements in efficiencies of CdTe/CdS solar cells over the past few decades have come from improving the short circuit current (JSC) and Fill Factor (FF) but the Open Circuit Voltage (VOC) has been stagnant. Further improvements in efficiencies should come from increased VOC’s. VOC’s can be improved by increasing the acceptor concentration and minority carrier lifetime. Both these parameters can be controlled by manipulating the native defect concentration in CdTe which can be achieved by varying CdTe stoichiometry.
In this study, a deposition system called Elemental Vapor Transport was used to vary the CdTe stoichiometry with an intent to change the native defect concentration and therefore pave way to increase acceptor concentration and lifetimes. Elemental cadmium and tellurium were heated in dedicated zones and their vapors were transported to the substrate using a carrier gas. By varying the temperatures and flowrates of the carrier gas through the zones, the gas phase Cd/Te ratio was varied to deposit Cd-rich, Te-rich and stoichiometric films.
Structural properties were investigated using Scanning Electron Microscopy (SEM), X-Ray Diffraction (XRD), and Transmission Electron Microscopy (EDS). Electrical characterization of completed devices was carried out by Current-Voltage (J-V), Capacitance-Voltage (C-V), and Spectral Response (SR) and Deep Level Transient Spectroscopy (DLTS) measurements.
Cd-rich films showed smaller grain sizes and lesser degree of preferential orientation. Te-rich films showed increased acceptor concentration and carrier lifetimes and solar cells fabricated using these films showed higher VOC’s compared to Cd-rich and stoichiometric films .Higher degree of CdTe-CdS mixing was observed at the interface for films deposited at increased substrate temperatures.

Identiferoai:union.ndltd.org:USF/oai:scholarcommons.usf.edu:etd-7848
Date07 April 2017
CreatorsEvani, Vamsi Krishna
PublisherScholar Commons
Source SetsUniversity of South Flordia
Detected LanguageEnglish
Typetext
Formatapplication/pdf
SourceGraduate Theses and Dissertations
Rightsdefault

Page generated in 0.007 seconds