As a result of the rise in processing power demands of today’s personal computers, water cooled pin fin heat sinks are increasingly being employed for the cooling of graphical processing units. Currently, these high performance devices are manufactured through high-cost, high-waste processes. In recent years, a new solution has emerged using the cold gas dynamic spray process, in which pin fins are directly manufactured onto a baseplate by spraying metallic powder particles through a mask. This process allows for a high degree of adaptability to different graphics processing unit shapes and sizes not achievable by any other process to date. One drawback of this process is that, as substrate sensitivity to heat and mechanical residual stresses requires the use of reduced spray parameters, there is reduced deposition efficiency, resulting in a fair portion of the feedstock powder being wasted. This work aims to demonstrate the feasibility of using powder recycling to mitigate this issue and compares coatings sprayed with reclaimed powder to their counterparts sprayed with as-received powder. The work demonstrates that cold gas dynamic spray is a highly flexible and economically competitive process for the production of pin fin heat sinks when using powder recycling even when spray parameters result in reduced deposition efficiency. The benefits of pin fins on heat transfer properties of flat plates used for graphical processing units is briefly addressed and demonstrated
| Identifer | oai:union.ndltd.org:uottawa.ca/oai:ruor.uottawa.ca:10393/38392 |
| Date | 05 November 2018 |
| Creators | Perry, Justin |
| Contributors | Jodoin, Bertrand |
| Publisher | Université d'Ottawa / University of Ottawa |
| Source Sets | Université d’Ottawa |
| Language | English |
| Detected Language | English |
| Type | Thesis |
| Format | application/pdf |
Page generated in 0.0181 seconds