Doctor of Philosophy / Department of Chemical Engineering / Keith L. Hohn / To characterize surface properties by current techniques, metal oxides typically have to be pre-treated at high temperature to remove surface absorbents. Therefore, a new low temperature method which can provide information on the surface chemistry is desired. In this work, the surface properties of metal oxide samples were studied by tetrakis(dimethylamino)ethylene (TDE) chemiluminescence (CL). This chemiluminescent method was also employed in probing the properties of reversed microemulsions.
It was found that the emission intensity vs. reaction time curve (I[subscript]t) of catalyzed TDE CL on MgO was affected by the distributions and types of surface hydroxyl groups. Isolated hydroxyls with lower coordination were found to have higher catalytic reactivity for the emission of TDE CL. Although hydrogen bonded hydroxyls also catalyze the TDE oxidation reaction, the influence on the light emission was negative. Because the properties of surface hydroxyls are associated with specific orientations of adjacent ions, information on surface hydroxyls can provide information about some general surface characteristics of a metal oxide.
When characterizing surface hydroxyls on Al[subscript]2O[subscript]3 by TDE CL, it was found that the catalytic reactivity of isolated hydroxyl groups is strongly associated with the stretching frequency of isolated hydroxyl. The stretching frequency of an isolated hydroxyl group is related to the modification of the adjacent ions and the coordination of the isolated hydroxyl. The results showed that the blue-shifts in the stretching frequencies of isolated hydroxyls led to increases in the catalytic reactivity of Al[subscript]2O[subscript]3 surfaces for the emission of TDE CL.
TDE CL was further applied in characterizing the surfaces of other metal oxides and chemically grafted Al[subscript]2O[subscript]3. The results indicated that the isolated hydroxyl groups with fewer adjacent ions likely have higher affinity for the binding of grafting agents. Higher emission intensities were obtained from catalyzed TDE CL on metal oxides featuring higher percentages of isolated hydroxyls.
The determination of a surfactant’s critical micellar concentration was accomplished by measuring the decay rate of the emission of TDE CL in a reversed microemulsion system. In this study, the CMC values of non-ionic and ionic surfactants were measured in different non-polar solvents.
| Identifer | oai:union.ndltd.org:KSU/oai:krex.k-state.edu:2097/1609 |
| Date | January 1900 |
| Creators | Huang, Chien-Chang |
| Publisher | Kansas State University |
| Source Sets | K-State Research Exchange |
| Language | en_US |
| Detected Language | English |
| Type | Dissertation |
Page generated in 0.0018 seconds