M.Ing. (Electrical And Electronic Engineering) / In this dissertation, an investigation into reducing Electromagnetic Interference (EMI) through design is presented. Root generation mechanisms of Electromagnetic Interference are often neglected during the design process and later treated symptomatically. Mitigation of Electromagnetic Interference at source often reduces cost and physical size of electronics. This dissertation demonstrates the process and results by which schematic balance mitigates EMI. In addition, the introduction of Geometric Balance and physically designing circuits to be Geometrically Symmetrical are presented and tested to determine whether the design produces mitigating EMI results. Multiple Printed Circuit Boards (PCB’s) were developed and tested against each other to demonstrate schematic balance and other EMI generation mechanisms. The final PCB was designed to be Geometrically Symmetrical and the test results compared. The results illustrate the varying performance of each PCB due to their differing design. The Geometrically Symmetrical PCB presented the best results due to various improvements which include physical layout size and semiconductor placement. An additional important phenomenon discovered was the amount of EMI generated during MOSFET Driver operation. This contributed to a significant amount of EMI during the no-load phase of testing.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:uj/uj:12335 |
| Date | 17 September 2014 |
| Creators | Burford, Steven Trefor |
| Source Sets | South African National ETD Portal |
| Detected Language | English |
| Type | Thesis |
| Rights | University of Johannesburg |
Page generated in 0.0035 seconds