Return to search

Robust power system stabilizer design.

This thesis investigates the design of damping controllers to alleviate the problem of
low frequency electro-mechanical oscillations in power systems. The operating point
and network parameters of power systems are continually changing, resulting in
changes in system dynamics. The conventional controller design methodology has
therefore come under increasing scrutiny for its lack of considerations for robustness.
The thesis first outlines the conventional design of a power system stabilizer (PSS) and
then applies two robust techniques (Hoo and Quantitative Feedback Theory, QFT) to the
design problem. The single machine infinite bus (SMIB) model is used to illustrate the
procedure for all three design techniques. The final design is undertaken to illustrate the
more important problem of robust multi-machine PSS design using QFT. The design
requires linearised models of the multi-machine system. A brief discussion is given on
how these can be obtained. An introduction to decentralized control design in QFT is
included to support the multi-machine design.
Chapter three proceeds through the design steps required to generate a conventional
PSS. The technique is shown to be simple for a given set of operating conditions. The
controller is shown to be adequately robust over the given set of operating conditions
albeit not by design.
Chapter four introduces a design technique that directly addresses robustness issues
during the controller design. For a restricted range of operating conditions the designed
controller demonstrates the desired robustness and performance characteristics. The
inherent difficulties with Hoo in PSS design become more apparent as the operating
range is extended.
Chapter five introduces the second robust controller design technique. QFT is shown to
be more adept at dealing with increased operating ranges and changing specifications in the single-machine infinite-bus case. The controller is easy to generate and performs
well over the entire range of operating conditions. QFT is also applied to the controller
design for a four-machine study system. The design is a marginally more complex than
in the single machine case but is still easily accomplished.
This thesis confirms previous attempts at solving the design problem using the methods
outlined above. The performance of all controllers is assessed for small and large
disturbances using non-linear time domain simulations with models developed using
PSCAD/EMTDC and MATLAB. / Thesis (M.Sc.)-University of Natal,Durban, 2002.

Identiferoai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:ukzn/oai:http://researchspace.ukzn.ac.za:10413/4785
Date January 2002
CreatorsMoodley, Devandren.
ContributorsBoje, Edward Sidney.
Source SetsSouth African National ETD Portal
LanguageEnglish
Detected LanguageEnglish
TypeThesis

Page generated in 0.0016 seconds