Return to search

Control of gain in conjugated polymers and perylene dyes

This thesis presents an investigation into the factors which control the gain and amplification properties in conjugated materials. Conjugated polymers and perylene dyes are highly fluorescent, are easy to process into thin films, and exhibit strong amplification over a broad gain bandwidth making them ideal for use in lasers and amplifiers. The stimulated emission created when thin films of the red emitting polymer poly(2-methoxy-5-(2'-ethylhexyloxy)- p-phenylenvinylene) (MEH-PPV) were photoexcited with high energy laser pulses was investigated. This was characterised by a dramatic narrowing of the emission spectrum which has been assigned to amplified spontaneous emission (ASE). The emission was found to have a gaussian profile and the gain coefficient was found to be 4 cm-1.The temperature dependence of the absorption, photoluminescence and ASE of films of MEH-PPV was measured. The effect of film morphology on the photophysical properties was investigated by using films cast from two spinning solvents, chlorobenzene (CB) and tetrahydrofuran (THE). Film morphology was found to greatly affect the temperature dependence. A particularly important property is the spectral position of the ASE and the factors which affect it. By controlling the film thickness close to the cut-off thickness for waveguiding in the polymer film it was shown that the peak position of the ASE could be tuned by 31 nm. Modelling of the waveguide modes in the polymer films was used to explain this effect. The cut-off wavelength for each film was measured and good agreement with the theory was found. In order to investigate ways in which energy transfer could be used to control the emission, two perylene dyes were used as a donor-acceptor pair in a host matrix of poly methymethacralate (PMMA). The position of the ASE was found to depend on the acceptor concentration. Measurements of the photoluminescence quantum yield and time-resolved luminescence measurements showed that the energy transfer coefficient was 5x10(^11)mol(^-1)d(^3)

Identiferoai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:341412
Date January 2001
CreatorsSheridan, A. K.
PublisherDurham University
Source SetsEthos UK
Detected LanguageEnglish
TypeElectronic Thesis or Dissertation
Sourcehttp://etheses.dur.ac.uk/4133/

Page generated in 0.0017 seconds