The problem of filtration of liquid aerosols by both wettable and nonwettable filters has been extensively studied and the results of the theoretical calculations together with the experimental results are presented. More realistic models of filtration by both wettable and nonwettable filters have been developed and verified experimentally. A new instrument has been developed, and used in the experiments, for the measurement of the absolute concentration of aerosols in the gas stream. This instrument is based on the measurement of the initial vapour content of the gas stream simultaneously with the measurement of the vapour content after the total evaporation of aerosol. The concentration of the aerosol is calculated as the difference between these two values. The instrument was developed to provide fast and accurate measurements of aerosol concentration. The main advantages of the instrument are: high accuracy, simplicity of measurement, possibility of use for a wide range of substances, perfect suitability of operation for automatic monitoring technologies, etc. All rights for this instrument have been reserved and the fully automatic version will be available in the near future. It was found that the efficiency of filtration of aerosol on the wettable filter depends on the thickness of the liquid film on the fibre. This parameter was taken into account in the development of a theoretical model of filtration on wettable fibrous filters. The particle breakthrough problem has been solved by the optimisation of the aspect ratio (the ratio of the height by width) of the wettable filter. On this basis, industrial devices have been developed, patented, and implemented in industry. These devices provide a stable operating efficiency of higher than 99%. It was found experimentally that the efficiency of filtration of aerosol on the nonwettable filter depends on the diameter of the drop suspended on the filter, and on the area of the filter blocked by drops: this influences the velocity of filtration. All these parameters were taken into account in the development of a theoretical model of filtration on nonwettable fibrous filters. On the basis of this model, satisfactorily verified by the experiments, an industrial device has been developed. The harnessing of atomisers makes it possible to maintain the efficiency of filtration higher than 99%, even with a relatively high velocity of filtration of 2.7m/s. The new technology is tackling the problem of handling huge amounts of exhaust gases and this is particularly important for cramped installations when the space available for the air pollution control technology is quite limited. A highly efficient gas cleaning technology has been developed. This technology is based on combining two stages (wet scrubber and filter) of currently utilised air pollution control devices by submerging the fibrous filter into the liquid on the plate. The new device provides an effective division of the main gas stream into ultra-small bubbles which increase the contact area between the gas and liquid phases. It was estimated theoretically and verified experimentally that the efficiency of the proposed 'combined' technology, is 45% higher than the efficiency of the two stages technology. The technology has been patented and will be offered for industrial implementation in the near future.
| Identifer | oai:union.ndltd.org:ADTP/194855 |
| Date | January 1995 |
| Creators | Agranovski, Igor Evgenevich, n/a |
| Publisher | Griffith University. School of Environmental Engineering |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://www.gu.edu.au/disclaimer.html), Copyright Igor Evgenevich Agranovski |
Page generated in 0.0015 seconds