Both Part I and Part II are included. / The separation of a mixture of glass spheres in water using 2 inch hydrocyclones was studied. <p> Three operating parameters were investigated: feed concentration, volume split and feed flow rate. In addition, three design parameters were cone angle, inlet diameter, and vortex finder length. The performance criterion parameters were the efficiency with which the solids were separated from the liquid, and the energy required per unit mass flowing through the hydrocyclone. </p> <p> First the experimental data were analyzed by three different statistical methods and the results compared in an attempt to determine which statistical method was most suitable for this two criteria system. The three methods were principal component analysis, canonical correlation analysis and multiple regression analysis. The theory behind these methods is briefly outlined. Our conclusion is that using all three methods give much more insight than could be obtained from any individual method. </p> <p> Second, an analysis of the above eight hydrocyclonc parameters of hydrocyclones with cylindrical sections indicated that for the range of parameters covered in this work, feed flow rate and inlet diameter influenced the energy loss most; volume split influenced the separation efficiency the most. Energy loss and separation efficiency are quite independent; this means that it is possible to design and run a hydrocyclone with high separation efficiency and low energy loss. The dilute concentrations used in this work indicate that a hydrocyclone of conventional design can be used in waste water treatment. When the parameters were correlated, a power model gave more consistent interpretation than a linear model. </p> <p> Third, the effect of the three operating parameters on hydrocyclones with three different body shapes suggested that the most efficient cyclone was one with a straight cone and no cylindrical section. The body shape dictated which parameters would significantly affect performance. </p> / Thesis / Master of Engineering (ME)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/18335 |
| Date | 12 1900 |
| Creators | Hsiang, Thomas C. H. |
| Contributors | Woods, D. R., Chemical Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0023 seconds