<p dir="ltr">Pea protein is one of the most used plant proteins in food products, acting as an alternative to conventional animal protein sources due to its abundant, nutritious, and ease in supply chain characteristics. The objective of this study was to investigate the impact of homogenization and UHT processing parameters on the properties of protein emulsion. Protein emulsions (8% w/w pea protein isolate and 1% w/w sunflower oil) were freshly prepared prior to processing, and the untreated sample was considered as the control (NT). The pilot-scale aseptic processing system (APS) used in this study consisted of two coil-in-shell heaters and two coolers. Samples flowed through each section of the APS system following this order: balance tank, pre-heater, final heater, hold tube, pre-cooler, and final cooler. The homogenizer was located either after the pre-cooler (AC) or the pre-heater (AH) with a controlled temperature of 165F. A third setup was utilized by bypassing the homogenizer in the UHT system. An additional 8-hour continuous run was conducted to mimic a commercial manufacturing operation by recirculating the protein emulsion in the UHT system, and fouling detections were made using a non-intrusive sensor (NICS). 5% w/w soy protein, 1% w/w sunflower oil oil-in-water emulsion was also used for fouling tests. Protein concentration, pH and zeta potential, Cryo-SEM microscopic image, particle size distribution, flocculation index (FI), coalescence index (CI), viscosity and color data were collected and analyzed. The protein concentration had a 23.20 ± 4.00 %, 28.35 ± 5.02 %, 27.98 ± 5.05% and 21.38 ± 5.75% reduction for AC, AH, UHT and NT samples, respectively, when compared with the initial concentration in the formula. AC, AH, UHT and NT samples had pH values of 7.24 ± 0.01, 7.27 ± 0.01, 7.28 ± 0.02, 7.41 ± 0.01, and zeta potential values of -42.91 ± 0.89, -47.30 ± 0.91, -46.91 ± 1.40 and -50.11 ± 1.47 mV. AC sample had a smaller and NT sample had a bigger, respectively, mean weighted size D 4,3 value than AH and UHT samples, which could also be seen in Cryo-SEM images where only AC images contained more visually observable smaller particles. FI and CI for AC, AH and UHT indicated the formation of flocs but no irreversible aggregations were found. Shear-thinning AC, AH, UHT and NT samples had viscosity decreases from 4.00 to 3.56, 3.88 to 3.75, 4.02 to 3.79 and 10.42 to 9.56 mPa*s in 1 1/s to 100 1/s shear rate range. NT sample had a very noticeable color difference from the other three treated samples. Overall, AC samples had similar or better emulsion stability in all aspects than AH and UHT samples, suggesting that AC processing could potentially be used in the protein beverage industry for manufacturing products with improved shelf stability. Severe foulants buildups were neither observed nor detected by a non-intrusive continuous sensor (NICS) in the UHT system within 8 hours of process for both pea protein and soy protein emulsion, indicating that this UHT-homogenization processing can potentially be adapted to current industrial practices for higher-quality protein beverages.</p>
| Identifer | oai:union.ndltd.org:purdue.edu/oai:figshare.com:article/24749610 |
| Date | 10 December 2023 |
| Creators | Xiang Cheng (17583861) |
| Source Sets | Purdue University |
| Detected Language | English |
| Type | Text, Thesis |
| Rights | CC BY 4.0 |
| Relation | https://figshare.com/articles/thesis/IMPACT_OF_HOMOGENIZATION_AND_UHT_PROCESSING_ON_THE_EMULSIFICATION_AND_PHYSICAL_PROPERTIES_OF_PEA_PROTEIN_BEVERAGES/24749610 |
Page generated in 0.0019 seconds