Return to search

Abs/polyamide-6 Blends, Their Short Glass Fiber Composites And Organoclay Based Nanocomposites: Processing And Characterization

The objective of this study is to process and characterize the compatibilized blends of
acrylonitrile-butadiene-styrene (ABS) and polyamide-6 (PA6) using olefin based
reactive copolymers and subsequently to utilize this blend as a matrix material in short
glass fiber (SGF) reinforced composites and organoclay based nanocomposites by
applying melt processing technique. In this context, commercially available epoxydized
and maleated olefinic copolymers, ethylene-methyl acrylate-glycidyl methacrylate
(EMA-GMA) and ethylene-n butyl acrylate-carbon monoxide-maleic anhydride
(EnBACO-MAH) were used as compatibilizers at different ratios. Compatibilizing
performance of these two olefinic polymers was investigated through blend
morphologies, thermal and mechanical properties as a function of blend composition and
compatibilizer loading level. Incorporation of compatibilizer resulted in a fine
morphology with reduced dispersed particle size. At 5 % EnBACO-MAH, the toughness
was observed to be the highest among the blends produced.
SGF reinforced ABS and ABS/PA6 blends were prepared with twin screw extrusion.
The effects of SGF concentration and extrusion process conditions on the fiber length
distribution, mechanical properties and morphologies of the composites were examined.
The most compatible organosilane type was designated from interfacial tension and
short beam flexural tests, to promote adhesion of SGF to both ABS and PA6. Increasing
amount of PA6 in the polymer matrix improved the strength, stiffness and also
toughness of the composites. Effects of compatibilizer content and ABS/PA6 ratio on
the morphology and mechanical properties of 30% SGF reinforced ABS/PA6 blends
were investigated. The most striking result of the study was the improvement in the
impact strength of the SGF/ABS/PA6 composite with the additions of compatibilizer.
Melt intercalation method was applied to produce ABS/PA6 blends based organoclay
nanocomposites. The effects of process conditions and material parameters on the
morphology of blends, dispersibility of nanoparticles and mechanical properties were
investigated. To improve mixing, the screws of the extruder were modified. Processing
with co-rotation yielded finer blend morphology than processing with counter-rotation.
Clays were selectively exfoliated in PA6 phase and agglomerated at the interface of
ABS/PA6. High level of exfoliation was obtained with increasing PA6 content and with
screw speed in co-rotation mode. Screw modification improved the dispersion of clay
platelets in the matrix.

Identiferoai:union.ndltd.org:METU/oai:etd.lib.metu.edu.tr:http://etd.lib.metu.edu.tr/upload/12608266/index.pdf
Date01 February 2007
CreatorsOzkoc, Guralp
ContributorsBayram, Goknur
PublisherMETU
Source SetsMiddle East Technical Univ.
LanguageEnglish
Detected LanguageEnglish
TypePh.D. Thesis
Formattext/pdf
RightsTo liberate the content for public access

Page generated in 0.0024 seconds