A comparison of the wet-spinning and dry-jet wetspinning of acrylic fibres has been carried out using a commercial acrylic polymer (Courtelle). redissolved in dimethyl formamide. The higher speeds possible in dry-jet wet-spinning have been related to the higher free velocity and the higher draw ratios possible. It is believed that the presence of the air-gap in dry-jet wet-spinning allows the removal of the dies well effects as well as other viscoelastic behaviour before coagulation and that this leads to fibres with superior mechanical properties, especially in improvements in extensibility. Conditions are described which allow the production of high tenacity acrylic fibres with tenacity up to 5.8 g/d tex. In an attempt to produce fibres with better mechanical properties under hot-wet conditions, copolymershave been prepared using bicyclo [2,2,1] hepta-2,5-diene as a comonomer. Fibres from such copolymers have low extensibilities and satisfactory fibres could be made only by incorporating, in addition to the bicyclo [2,2,1] hepta-2,5-diene monomer, itaconic acid and by dry-jet wet-spinning. In one such case a fibre was obtained with a slightly higher hot-wet modulus and a considerably reduced hot-wet extensibility when compared with Courtelle fibre
Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:235436 |
Date | January 1982 |
Creators | Nourpanah, Parviz |
Contributors | East, G. C. |
Publisher | University of Leeds |
Source Sets | Ethos UK |
Detected Language | English |
Type | Electronic Thesis or Dissertation |
Source | http://etheses.whiterose.ac.uk/2199/ |
Page generated in 0.0126 seconds