IsaMill is a stirred type mill used in mineral industry for fine and ultra-fine grinding. The difficulty in obtaining the internal flow information in the mill by experimental techniques has prevented the development of the fundamental understanding of the flow and generating general methods for reliable scale-up and optimized design and control parameters. This difficulty can be effectively overcome by numerical simulation based on discrete element method (DEM). In this work a DEM model was developed to study particle flow in a simplified IsaMill. The DEM model was validated by comparing the simulated results of the flow pattern, mixing pattern and power draw with those measured from a same scale lab mill. Spatial distributions of microdynamic variables related to flow and force structure such as local porosity, particle interaction forces, collision velocity and collision frequency have been analyzed. Among the materials properties of particles, it is shown that by decreasing particle/particle sliding friction coefficient, the particle flow becomes more vigorous which is useful to grinding performance. Restitution coefficient does not affect the particle flow significantly. A too low or too high particle density could decrease grinding efficiency. Although grinding medium size affects the flow, its selection may depend on the particle size of the products. Among the operational variables considered, the results show that fill volume and mill speed proved to be important factors in IsaMil process. Increase of fill volume or mill speed increases the interaction between particles and agitating discs which results in a more vigorous motion of the particles. Among the mill properties, particle/stirrer sliding friction plays a major role in energy transfer from stirrer to particles. Although there exists a minimum collision energy as particle/stirrer sliding friction increases, large particle/stirrer sliding friction may improve grinding performance as it has both large collision frequency and collision energy. However, that improvement is only up to a critical particle/disc sliding friction beyond which only input energy increases with little improvement on collision frequency and collision energy. Reducing the distance between stirrers or increasing the size of disc holes improves high energy transfer from discs to particles, leading to high collision frequency and collision energy. Among the different stirrer types, the energy transfer is more effective when disc holes are present. Pin stirrer shows increased collision energy and collision frequency which also result in a high power draw. Using the DEM results, a wear model has been developed to predict the wear pattern of the discs. This model can be used to predict the evolution of the disc wear with the time. It is shown that energy transfer from discs to particles are increased when discs are worn out. An attempt has also been made to analyze the microdynamic properties of the mill for different sizes. It is shown that specific power consumption and impact energy are correlated regardless of the mill size and mill speed.
| Identifer | oai:union.ndltd.org:ADTP/187471 |
| Date | January 2007 |
| Creators | Jayasundara, Chandana Tilak, Materials Science & Engineering, Faculty of Science, UNSW |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://unsworks.unsw.edu.au/copyright, http://unsworks.unsw.edu.au/copyright |
Page generated in 0.0019 seconds