Return to search

Planar rotary Energy Harvester fabricated by PCB technology

Small and efficient energy harvesters, as a renewable power supply, draw lots of attention in last few years. This thesis presents a planar rotary electromagnetic generator with copper coils fabricated by printed circuit board (PCB) as inductance and Nd-Fe-B magnets as magnetic member. Coils are fabricated on PCB, which is presumably cost-effective and promising methods. 28-pole Nd-Fe-B magnets with outer diameter of 50 mm and thickness of 2 mm was sintered and magnetized, which can provide magnetic field of 1.4 Tesla. This harvester consists of planar multilayer with multi-pole coils and multi-pole permanent magnet, and the volume of this harvester is about 50x50x2.5 mm3. Finite element analysis is used to design energy harvesting system, and simulation model of the energy harvester is established. In order to confirm the simulation, experiment data are compared with simulation result. The PCB energy harvester prototype can generate induced voltage 1.11 V and 26.54mW output power at rotary speed of 4,000 rpm, and the efficiency of this energy harvester is 31.5%.

Identiferoai:union.ndltd.org:NSYSU/oai:NSYSU:etd-1217112-173845
Date17 December 2012
CreatorsChen, Po-Hsiu
ContributorsS. C. Shen, C. T. Pan, C. C. Nien
PublisherNSYSU
Source SetsNSYSU Electronic Thesis and Dissertation Archive
LanguageCholon
Detected LanguageEnglish
Typetext
Formatapplication/pdf
Sourcehttp://etd.lib.nsysu.edu.tw/ETD-db/ETD-search/view_etd?URN=etd-1217112-173845
Rightsuser_define, Copyright information available at source archive

Page generated in 0.002 seconds