Return to search

Čištění energoplynu z biomasy v katalytickém vysokoteplotním filtru / Syngas Cleaning in Hot Catalytic Filter

Disertation thesis deals with development of hot dolomite filter for the purposes of cleaning of gas polluted by biomass and waste gasification with ash and tar as well as sulphur and chlorine compounds as main pollutants. Gas is then cleaned so that it can be utilized in cogeneration units with combustion engines. This supports advancement of gasification techniques using decentralized power and heat generation especially for design of small scale units. Concrete aims of this thesis are stated in chapter 2. Experimental fluid gasification stend Biofluid 100 has been in operations at Brno University of Technology (BUT) since 2000 and it helps research of biomass and waste gasification. Development of the filter initially utilized needs and experience with the utility during cooperation of BUT and ATEKO Hradec Králové. Water scrubber was used for gas cleaning, however, this method proved to be ineffective. Alternative solutions were considered. Based on literature search, natural catalysts with limestone basis were opted. First part of the thesis presents literature search of this issue. Historic development and description of gasification process are briefly discussed as well as elementary classification of gasification generators. This part is followed by chapters dealing with gas pollutants. Tar – the most significant pollutant – is discussed in a separate chapter which presents tar formation, its classification, characteristics and methods for its removal. Brief summary of requirements on gas properties with respect to its utilization in various applications (especially in cogeneration units) follows. Other part of the literature search part focuses on methods of removal of tar from gas, especially on catalyst methods. Dolomite characteristics, description of dolomite calcination as well as simplified kinetic model of tar cracking using dolomite are presented. Based on literature search, laboratory and verification equipment was designed for the purposes of dolomite properties testing. Equipment description as well as description of experimental stend Biofluid 100 where the experimental tests were carried out can be found in introduction of the experimental part. This is followed by a complete description of pilot equipment design of hot dolomite filter with general description of experimental work process, brief characteristics of the fuel and catalytic material used. Final part of the work comprises of experiment results that were carried out on the pilot equipment. Focus is on efficiency of tar removal in connection with operation temperature, amount of catalytist and material used. Influence of these parameters on gas composition and energy intensity of the whole process under these conditions is mentioned as well. Possibility of autonomous unit operations without electricity heating is briefly outlined. Summary of the most significant results including the potential of future hot dolomite filter development is stated the final part of the thesis.

Identiferoai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:233838
Date January 2009
CreatorsLisý, Martin
ContributorsSkála, Zdeněk
PublisherVysoké učení technické v Brně. Fakulta strojního inženýrství
Source SetsCzech ETDs
LanguageCzech
Detected LanguageEnglish
Typeinfo:eu-repo/semantics/doctoralThesis
Rightsinfo:eu-repo/semantics/restrictedAccess

Page generated in 0.0024 seconds