This study investigated the crop density in a New Holland BB960 (branch of CNH Global N.V.) large square baler as examined by crop trajectory from the precompression room to the bale chamber. This study also examined both the top and bottom plunger pressures and critical factors affecting the final top and bottom bale densities.<p>The crop trajectories (wad of crop) were measured using a high-speed camera from the side of the baler through viewing windows. The viewing windows were divided into four regions for determining the crop displacement, velocity and acceleration. Crop strain was used to evaluate the potential change in density of the crop before being compressed by the plunger. Generally, the vertical crop strain was found to be higher in the top half of the bale compared to the bottom. <p>Average strain values for side measurements were 12.8% for the top and 2.1% for the bottom. Plunger pressures were measured to compare peak pressures between the top and bottom halves of each compressed wad of crop, and to develop pressure profiles based on the plungers position. Results of comparing the mean peak plunger pressures between the top and bottom locations indicated the mean pressures were significantly higher at the top location with the exception of one particular setting. Resulting pressure profile graphs aided in qualitatively describing the compression process for both top and bottom locations.<p>A stepwise regression model was developed to examine the difference in material quantity in the top half of the bale compared to the bottom, based on bale weights. The model indicated that flake setting, stuffer ratio and number of flakes had the greatest effect on maintaining consistent bale density by comparing top to bottom halves of each bale. The R2 (coefficient of determination) value for the developed model was of 59.9%. The R2 was low although could be accounted for due to the limited number of data points in the developed model.
| Identifer | oai:union.ndltd.org:USASK/oai:usask.ca:etd-10302007-101558 |
| Date | 01 November 2007 |
| Creators | Remoué, Tyler |
| Contributors | Roberge, Martin |
| Publisher | University of Saskatchewan |
| Source Sets | University of Saskatchewan Library |
| Language | English |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://library.usask.ca/theses/available/etd-10302007-101558/ |
| Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0063 seconds