The production of advanced high strength steels (AHSS) for use in the automotive and construction industries requires complex control of runout table (ROT) cooling. Advanced high strength steels require coiling at temperatures below 500 °C in order to produce a complex multi-phase microstructure. The research described here will investigate the boiling conditions that occur for moving plate experiments when steel is cooled towards low coiling temperatures.
Experiments were performed on a pilot-scale ROT located at the University of British Columbia using industrially supplied steel plates. Tests were performed for four different speeds (0.3, 0.6, 1.0 and 1.3 m/s) and three different initial plate temperatures(350, 500 and 600 °C). Each plate was instrumented with thermocouples in order to record the thermal history of the plate.
The results show that cooling is more effective at slower speeds within the stagnation zone for surface temperatures over 200 °C. Outside the stagnation zone regardless of speed cooling is primarily governed by air convection and radiation with minor effects from latent heat caused by splashing water. The maximum peak heat flux value increases with decreasing speed and occurs at a surface temperature of approximately 200 °C, regardless of speed. Below a surface temperature of 200 °C, speed has a negligible effect on peak heat flux. The maximum integrated heat flux seems to vary with speed according to a second order polynomial.
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:BVAU.2429/401 |
| Date | 05 1900 |
| Creators | Chan, Phillip |
| Publisher | University of British Columbia |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
Page generated in 0.0021 seconds