Return to search

Analýza řezání tenkostěnných součástí pilou / On the analysis of thin-wall parts sawing

Master‘s thesis deals with sawing of the thin-walled parts with high speed steel slitting saw. At first the most used conventional and unconventional possibilities of materiál cutting are described by a form of search. The next chapter describes forces arising from splitting saw machining, including their dependence on a specific cutting force, a chip cross section and a engagement angle. The second part of the thesis deals with the technological improvement of the cutting process, where three possible solutions are considered – geometry of the cutting tool, PVD coating deposition of the cutting tool and process fluid change. In the experimental part non coated slitting saw with burrs, non coated deburred slitting saw and coated slitting saws are compared. Used coatings were Ti(C,N), Cr-Al-Si-N, Al-Cr-B-N, and TripleCoating Cr, which is consisting of three layers TiN + (Al,Ti)N + Cr-Al-Si-N. The experiment has shown that the cutting forces inceases as the edge radius and wear level of the cutting tool increases. Coated cuttung tools has shown lower differences between the first and the last cut. Slitting saws have been also used in real cutting process to verify experimental results.

Identiferoai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:379007
Date January 2018
CreatorsSpáčil, Radek
ContributorsDvořáková, Jana, Píška, Miroslav
PublisherVysoké učení technické v Brně. Fakulta strojního inženýrství
Source SetsCzech ETDs
LanguageCzech
Detected LanguageEnglish
Typeinfo:eu-repo/semantics/masterThesis
Rightsinfo:eu-repo/semantics/restrictedAccess

Page generated in 0.0022 seconds