Return to search

The techno-economics of bitumen recovery from oil and tar sands as a complement to oil exploration in Nigeria / E. Orire

The Nigeria economy is wholly dependent on revenue from oil. However, bitumen has been discovered in
the country since 1903 and has remained untapped over the years. The need for the country to
complement oil exploration with the huge bitumen deposit cannot be overemphasized. This will help to
improve the country's gross domestic product (GDP) and revenue available to government. Bitumen is
classifled as heavy crude with API (American petroleum Institute) number ranging between 50 and 110
and occurs in Nigeria, Canada, Saudi Arabia, Venezuela etc from which petroleum products could be
derived.
This dissertation looked at the Canadian experience by comparing the oil and tar sand deposit found in Canada with particular reference to Athabasca (Grosmont, Wabiskaw McMurray and Nsiku) with
that in Nigeria with a view of transferring process technology from Canada to Nigeria. The Nigeria and Athabasca tar sands occur in the same type of environment. These are the deltaic, fluvial marine deposit in an incised valley with similar reservoir, chemical and physical properties. However, the Nigeria tar sand is more asphaltenic and also contains more resin and as such will yield more product volume during
hydro cracking albeit more acidic. The differences in the components (viscosity, resin and asphaltenes
contents, sulphur and heavy metal contents) of the tar sands is within the limit of technology adaptation.
Any of the technologies used in Athabasca, Canada is adaptable to Nigeria according to the findings of this research.
The techno-economics of some of the process technologies are. x-rayed using the PTAC (petroleum
technology alliance Canada) technology recovery model in order to obtain their unit cost for Nigeria
bitumen. The unit cost of processed bitumen adopting steam assisted gravity drainage (SAGD), in situ
combustion (ISC) and cyclic steam stimulation (CSS) process technology is 40.59, 25.00 and 44.14
Canadian dollars respectively. The unit cost in Canada using the same process technology is 57.27, 25.00
and 61.33 Canadian dollars respectively. The unit cost in Nigeria is substantively lesser than in Canada.
A trade off is thereafter done using life cycle costing so as to select the best process technology for the
Nigeria oil/tar sands. The net present value/internal rate of return is found to be B$3,062/36.35% for
steam assisted gravity drainage, B$I,570124.51 % for cyclic steam stimulation and B$3,503/39.64% for in
situ combustion. Though in situ combustion returned the highest net present value and internal rate of
return, it proved not to be the best option for Nigeria due to environmental concern and response time to
production. The best viable option for the Nigeria tar sand was then deemed to be steam assisted gravity
drainage.
An integrated oil strategy coupled with cogeneration using MSAR was also seen to considerably amplify
the benefits accruable from bitumen exploration; therefore, an investment in bitumen exploration in
Nigeria is a wise economic decision. / Thesis (M.Ing. (Development and Management))--North-West University, Potchefstroom Campus, 2010.

Identiferoai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:nwu/oai:dspace.nwu.ac.za:10394/5704
Date January 2009
CreatorsOrire, Endurance
PublisherNorth-West University
Source SetsSouth African National ETD Portal
Detected LanguageEnglish
TypeThesis

Page generated in 0.0023 seconds