Return to search

Indirect Fabrication of Lattice Metals with Thin Sections Using Centrifugal Casting

There is a wide range of applications for 3D printing technology with an additive manufacturing such as aerospace, automotive, marine and oil/gas, medical, consumer, electronics, building construction, and many others. There have been many pros and cons for 3D additive manufacturing. Even though 3D printing technology has many advantages: freedom to design and innovate without penalties, rapid iteration through design permutations, excellence mass customization, elimination of tolling, green manufacturing, minimal material wastes, energy efficiency, an enablement of personalized manufacturing. 3D additive manufacturing still has many disadvantages: unexpected pre- and post-processing requirement, high-end manufacturing, low speed for mass production, high thermal residual stress, and poor surface finish and dimensional accuracy, and many others. Especially, the issues for 3D additive manufacturing are on high cost for process and equipment for high-end manufacturing, low speed for mass production, high thermal residual stress, and poor surface finish and dimensional accuracy. In particular, it is relatively challenging to produce casting products with lattice or honeycomb shapes having sophisticated geometries. In spite of the scalable potential of periodic cellular metals to structural applications, the manufacturing methods of I∙AM Casting have been not actively explored nor fully understood. A few qualitative studies of I∙AM Casting has been reported. Recently, a sand casting of cellular structures was attempted, resulting in casting porosity and the sharp corners in the lattice structure of the cellular structural molds, a sharpness which prevent fluid-flow and causes undesired solidification, resulting in misrun casting defects. Research on the indirect AM methods has not been aggressively conducted due to the highly complex and multidisciplinary problems across the process – continuum modeling (thermal stress, flow, heat transfer, and water diffusion) with multiple materials (polymer, metals, and ceramic) for multiphase simulations – solid, liquid, and gas. As an initial step to fully understand the processing of I∙AM Casting, a quantitative study on I∙AM Casting is conducted in this work.

Identiferoai:union.ndltd.org:unt.edu/info:ark/67531/metadc822758
Date12 1900
CreatorsMun, Jiwon
ContributorsJu, Jaehyung, 1973-, Choi, Tae-Youl, Reidy, Richard F., Li, Xiaohua
PublisherUniversity of North Texas
Source SetsUniversity of North Texas
LanguageEnglish
Detected LanguageEnglish
TypeThesis or Dissertation
Formatxi, 127 pages : illustrations (chiefly color), Text
RightsPublic, Mun, Jiwon, Copyright, Copyright is held by the author, unless otherwise noted. All rights Reserved.

Page generated in 0.0017 seconds