The use of MEMS-based inertial sensors for a relative positioning estimation system
(RPES) was investigated. A number of data acquisition and processing techniques are
developed and tested, to determine which one would provide the best performance of the
proposed method. Because inertial-based sensors don’t rely on other references to
calibrate their position and orientation, there is a steady accumulation of errors over time.
The errors are caused by various sources of noise such as temperature and vibration, and
the errors are significant. This work investigates various methods to increase the signalto-
noise ratio, in order to develop the best possible RPES method. The main areas of this
work are as follows: (i) The proposed RPES application imposes specific boundary
conditions to the signal processing, to increase the accuracy. (ii) We propose that using
redundant inertial rate sensors would give a better performance over a single rate sensor.
(iii) We investigate three Kalman filter algorithms to accommodate different
combinations of sensors: Parallel sensors arrangement, Series sensors arrangement, and
compression arrangement. In implementing these three areas, the results show that there
is much better improvement in the data in comparison to using regular averaging
techniques. / Graduate
Identifer | oai:union.ndltd.org:uvic.ca/oai:dspace.library.uvic.ca:1828/3495 |
Date | 24 August 2011 |
Creators | Balkhair, Hani |
Contributors | Dechev, Nikolai |
Source Sets | University of Victoria |
Language | English, English |
Detected Language | English |
Type | Thesis |
Rights | Available to the World Wide Web |
Page generated in 0.0018 seconds