This study was concerned with the performance of biofuels in diesel engines. Generally, the basic combustion and emission characteristics of Rapeseed Oil (RSO) and Soya Oil (SO) result in a lower in-cylinder pressure peak than diesel. This led to the reduction of Nitrogen Oxides (NOx) emissions and to relatively high soot emissions. Further measurements of RSO were done in order to investigate the influence of injection pressure, injection timing and Exhaust Gas Recirculation (EGR) on combustion and emission characteristics. A high soot emission from RSO was reduced by increased injection pressure. Moreover, injection timing also had to be varied in order to reduce the soot emissions from RSO. The retarded injection timing (3 deg bTDC) and increased injection pressure (1200 bar) for the blend of 30% RSO resulted in a reduction of soot emission to the same level as from diesel fuel. Further investigation regarding the soot emissions was done for Rapeseed Methyl Ester (RME) under turbocharged engine operation. The application of the boost pressure resulted in stable engine operation at a late injection timing of 5 deg aTDC. A simultaneous reduction of soot and NOx emissions has been achieved for RME at an injection timing of TDC and high EGR percentage (40 – 50 %). The soot particles size distribution under different engine operating conditions for RME and diesel has also been investigated. Moreover, the characteristic of Electrostatic Mobility Spectrometer (EMS) and the design of primary dilution system have been provided in order to understand the influence of the dilution process and to obtain more real results. Generally, RME showed less particles concentration in the nucleation mode when compared to diesel. Moreover, high EGR caused a shift of the particles from the nucleation mode by agglomeration into the accumulation mode for both fuels. The effect of injection pressure could only be seen in the accumulation mode, where high injection pressure slightly reduced the concentration number. The soot emission was effectively reduced by the usage of the diesel particulate filter (DPF). For this purpose, the soot particles size distributions before and after the DPF have been measured at different engine speeds and loads. At low engine torque, the soot was effectively filtered while the operation under high engine loads resulted in low soot particle concentration especially in the nucleation mode, after the DPF.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:539930 |
| Date | January 2010 |
| Creators | Labecki, Lukasz |
| Contributors | Ganippa, L. : Zhao, H. |
| Publisher | Brunel University |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | http://bura.brunel.ac.uk/handle/2438/5840 |
Page generated in 0.045 seconds