This dissertation thesis deals with the measurement of insulation resistance for rotating electrical machines and polarization indices calculated from them. The first part contains a short theoretical introduction, methods of measurement and basic formulas for calculations. The second part discusses the results obtained in laboratory measurements in both the model and the real coil of high voltage machine. There are also elucidated some of the principles and causes of some phenomena with which the measurement of insulation resistance is encountered. The third part deals with the results of measurements on real machines. There are mainly discussed the dependences of insulation resistance and polarization index on the influences that occur in measurements such as temperature measured insulation, moisture in the insulation, but also the influence of measuring instruments on the measured values. It is also expressed how much these factors affect the measurement results. In addition, this part deals with some other influences that have a negative affect on the measurement of insulation resistance. There is processed a new methodology for measuring insulation resistence in the fourth part of this thesis. The need to develop a metodology of measuring is based on the needs of engineering practice, where is considerable inconsistency of measurement in the present time. Measurement, and often performed on the same machine, are not nowadays often comparable, because measurements are not met even the basic rules resulting from the findings of research and development, which were discovered in the last few decades. Measurement of insulation resistance in our nowdays methodology stagnated on the level of the seventies of 20th century. For this reason, we have developed a new methodology of measurement that takes into account all significant influences affecting the measurement. The purpose of the methodology is to ensure full repeatability and comparability of measurements not only on the same machine but on machines of the same type, in optimal cases, the machines of different types. There are the chapters "The objectives of the work" and "Conclusion" the part of the work. A very important chapter is "The contribution of thesis", which summarizes the original results of this work and results, the use of which is expected in engineering practice.
| Identifer | oai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:233987 |
| Date | January 2011 |
| Creators | Pavlík, Josef |
| Contributors | Radek,, Szabó, Singule, Vladislav, Hammer, Miloš |
| Publisher | Vysoké učení technické v Brně. Fakulta strojního inženýrství |
| Source Sets | Czech ETDs |
| Language | Czech |
| Detected Language | English |
| Type | info:eu-repo/semantics/doctoralThesis |
| Rights | info:eu-repo/semantics/restrictedAccess |
Page generated in 0.002 seconds