The objective of this project is to develop a methodology to measure and predict the strength and the stiffness of red alder (Alnus rubra) nailed pallet connections subjected to repetitive loading. Joint tests were conducted to define the mechanical properties of bottom block pallet connections. The primary tests were conducted to define the strength and stiffness of joint specimens tested in cyclic lateral loading, using three different side member thicknesses and four types of nails. Also, the influence of other specific variables on joint performance was evaluated including friction, pattern, moisture content, number of nails per joint, specific gravity, and rate of loading. In total, 23 sets of nailed joint specimens, with 15 replications each, were constructed and tested. The use of a reversing cyclic lateral loading procedure permits documentation of the effect of dynamic loading on the load-slip response of the connection. Analysis of the data included the creation of two envelope curves, the initial and the final (stabilized) curve. The data obtained from the two curves was used to find the “best” model for predicting the strength and stiffness of the connections. Four models were identified but only one of these was found useful for prediction purposes. Finally, experimental capacity loads were found to be at least three times greater than the national design specification allowable design loads. / Master of Science
| Identifer | oai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/41940 |
| Date | 07 April 2009 |
| Creators | Sosa, Hector M. |
| Contributors | Wood Science and Forest Products |
| Publisher | Virginia Tech |
| Source Sets | Virginia Tech Theses and Dissertation |
| Language | English |
| Detected Language | English |
| Type | Thesis, Text |
| Format | xvii, 197 leaves, BTD, application/pdf, application/pdf |
| Rights | In Copyright, http://rightsstatements.org/vocab/InC/1.0/ |
| Relation | OCLC# 32378523, LD5655.V855_1994.S697.pdf |
Page generated in 0.0017 seconds