<i>Lactobacillus plantarum</i> (<i>Lb. plantarum</i>) NRRL B4496 and <i>Lactococcus lactis</i> (<i>Lc. lactis</i>) NRRL B1821 prolidase genes were isolated, cloned, and sequenced. The sequence-confirmed genes were subcloned into the expression systems. The recombinant prolidases from the pKK223-3 systems were purified through ammonium sulphate precipitation and anion-exchange column chromatography. Recombinant <i>Lb. plantarum prolidase</i>, however, demonstrated a loss of activity during the purification. The following characterization work was performed on purified recombinant <i>Lc. lactis prolidase</i>. <p>The mass spectroscopic result and the molecular modelling suggested a 80 kDa homodimer with two metal cations at the catalytic centre of the prolidase. The optimum temperature was 50 ºC and showed more than 50% activities between 40 and 55 ºC. The enzyme was most stable at 30 ºC and withstood 20 min of heat-treatment up to 60 ºC, however, lost activity over 70 ºC. Circular dichroism indicated a denaturation temperature of 67 ºC. The optimum pH was 6.5 for hydrolyzing Leu-Pro and the enzyme did not display any activity below pH 5.5 nor above pH 7 with this peptide. However, Phe-Pro was hydrolyzed the fastest at pH 7 and Arg-Pro had a maximum rate at pH 9. This metallopeptidase exhibited a broad range of metal cation preference, hydrolyzing Leu-Pro with Mn++, Co++, Zn++, Ca++, and Mg++. Further kinetic analysis showed unusual allostery of the enzyme (Hill coefficient: 1.3). The unique substrate intakes onGlu-Pro and tripeptides were observed while Val-Pro was not hydrolyzed. The molecular modelling of this prolidase suggested a difference in the substrate specificity resulting from a loop structure, L33 to R40, near the substrate binding site.
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:SSU.etd-04142007-123803 |
| Date | 23 April 2007 |
| Creators | Yang, Soo In |
| Contributors | Shand, Phyllis J., Korber, Darren R., Tanaka, Takuji |
| Publisher | University of Saskatchewan |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://library.usask.ca/theses/available/etd-04142007-123803/ |
| Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.009 seconds