Return to search

Atomistic simulation studies of lithiated MnO2 nanostructures

Thesis (Ph.D.(Physics)) -- University of Limpopo, 2020 / We employ molecular dynamics simulations, using DL_POLY code, to study the structural behaviour of β-MnO2 cathode material during discharging through lithium-ion intercalation into the bulk, nanoparticle, nanorod, nanosheet, and nanoporous β-MnO2. It is shown that lithium-ions have an average coordination number of about 5.70 and prefer surface sites with high oxygen coordination. The average lattice parameter values at intercalation of 0.85 Li/Mn are found to be under 4% relative to the experimental values obtained at 0.92 Li/Mn. Moreover, all the lithiated β-MnO2 structures did not collapse at 0.85 Li/Mn as observed in the β-MnO2 mesoporous in experimental work. As lithium is limited, sodium is a good alternative charge carrier in lithium-ion batteries. As a result, we have also performed studies on sodium intercalation into bulk, nanoparticle, nanorod, nanosheet and nanoporous β-MnO2. The microstructures and radial distribution functions show that the β-MnO2 structures could be intercalated up to 0.24 Na/Mn without any obvious structural degradation. Beyond this sodium concentration, the microstructure collapses and become amorphous thus predicting a potentially lower capacity for Na-MnO2-β batteries. Also, as the voltage is an important factor in the energy density of lithium-ion batteries, we have studied the trends in the average intercalation potentials in relation to the various nano architectures. The trend, in increasing value of average intercalation potentials, were found to be bulk structure, nanorod, nanosheet, nanoporous and nanoparticle. This suggests that nanostructuring can enhance cell voltage.
Mechanical properties studies on the pure and lithiated bulk and nanorod β-MnO2 were also performed through uniaxial compressive and tensile strain application. The results show that under compressive strain the bulk structure and nanorod mitigate stress through the contraction and collapse of the inherent tunnel structures, known to cause electrochemical inactivity, and also through the shifting of the MnO6 octahedral planes. The collapsing of tunnels was found to occur more on the bulk structure and less on the nanorod, while the MnO6 octahedral plane shifts were found to occur more on the nanorod and less on the bulk structure. Unoccupied 1x2 or conjoined 1x2 were found to result in structural collapse irrespective of the host nanoarchitecture. The X-ray diffraction pattern
(v)
plots suggest that lithium intercalation and compressive stress application have a similar impact on the underlying structure of the various nanostructures. The microstructure analysis for bulk β-MnO2 under tensile strain reveals that fracture occurred in the brookite region and along the dislocation/stacking fault. The nanorod β-MnO2 mitigated stress through a rutile-to-brookite phase transition which occurred in the unstrained Li0.73MnO2-β and under tensile strain in LixMnO2-β for x = 0.00, 0.03, 0.12, and 0.24. In both the bulk and nanorod β-MnO2 the brookite phase was succeeded by structural breakdown leading to fracture and served as an indicator for imminent structural failure upon more tensile strain application. / National Research Foundation (NRF)

Identiferoai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:ul/oai:ulspace.ul.ac.za:10386/3358
Date January 2020
CreatorsKgatwane, Kenneth Mompati
ContributorsNgoepe, P. E.
Source SetsSouth African National ETD Portal
LanguageEnglish
Detected LanguageEnglish
TypeThesis
Formatxxi, 155 leaves
RelationPDF

Page generated in 0.0024 seconds