An electrochemical detection method based on long range surface plasmon waveguides is proposed and demonstrated in this integrated article thesis. This dissertation uses CYTOP gold (Au) waveguides supporting long range surface plasmon polaritons (LRSPPs) in conjunction with grating couplers as well as Au waveguides embedded on a one-dimensional photonic crystal (1DPC) supporting Bloch LRSPPs integrated grating couplers.
Grating couplers for Au stripe waveguides embedded in Cytop are demonstrated and analyzed. Grating couplers are used in a broadside coupling scheme where a laser beam incident on a stripe of Au on Cytop. The use of gratings for excitation of LRSPPs simplifies optical alignment and does not require high-quality input and output edge facets. Over a broad operating wavelength range, optical experiments are performed to demonstrate coupling loss and determine the efficiency of grating coupling using both a cleaved bow-tie PM fiber and a lensed PM fiber. The coupling loss and grating coupling efficiency of both types of fibers are also calculated numerically.
Fluoropolymers with refractive indices close to water, such as CYTOP, are widely used to make waveguide biosensors today. Due to its low glass transition temperature, CYTOP presents limitations to fabrication processes. A truncated 1D photonic crystal may replace a low-index polymer cladding such as CYTOP to support Bloch LRSPPs within the bandgap of the 1DPC over limited wavenumbers and wavelength range.
As a result of the high sensitivity of Au stripe Bloch LRSPP waveguide biosensors and their compatibility with high levels of integration, microelectrode systems that can be integrated with such optical biosensors are examined. A chip bearing a Au LRSPP waveguide that can also function as a working electrode (WE), a Pt counter electrode (CE), and Pt/Cu electrical contact pads, is used to demonstrate the electrochemical performance of LRSPPs waveguides. The cyclic voltammetry measurements were performed at different scan rates and concentrations of potassium ferricyanide as the redox species on Au LRSPPs waveguides. By fitting our experimental data to the Randles-Sevcik equation, we find the diffusion coefficient of potassium ferricyanide. The results from CV measurements obtained from chips are compared with commercial macroscopic electrodes. The CV measurements are also compared with theoretical results computed using the Butler-Volmer equation to determine the rate constant of the redox species at zero potential.
A waveguide containing a stripe of Au that propagates infrared surface plasmon polaritons (SPPs), acting simultaneously as an electrode in a three-electrode electrochemical cell is also examined. Under SPP excitation, cyclic voltammetry was measured as a function of incident optical power and wavelength (1350 nm). In oxidation and reduction reactions, energetic electrons are separated from energetic holes. Under SPP excitation, redox current densities increase by 10×. With the SPP power, the oxidation, reduction, and equilibrium potentials drop by as much as 2× and separate in correlation with the photon energy. According to electrochemical impedance spectroscopy, charge transfer resistance dropped by almost 2× under SPP excitation. During SPP excitation, the temperature of the working electrode is monitored in situ and independent control experiments are performed to isolate thermal effects. Measurements of chronoamperometry with SPPs modulated at 600 Hz yield a rapid current response modulated at the same frequency, ruling out thermally enhanced mass transport. The observation is attributed to the opening of optically controlled non-equilibrium redox channels associated with the energetic carrier transfer to the redox species. During CV and chronoamperometry measurements, convolutional voltammetry is performed by monitoring the SPP output power versus the applied voltage. Using both experimental and theoretical methods, we demonstrate that the SPP output power is proportional to the electrochemical current convolution. A SPP voltammogram confirms that signal changes are mainly caused by differences in refractive index between reduced and oxidized forms of redox species. In addition, we demonstrate that energetic carriers resulted from SPP absorption significantly improved electrochemical sensitivity.
As a complementary electrochemical technique, convolutional voltammetry is useful since the signal is related directly to the concentration of electroactive species on the working electrode (WE) and independent of the scan rate. As a probe of electrochemistry taking place in waveguides, surface plasmon polaritons (SPPs) propagating along one are sensitive. In such a waveguide, the optical output power is proportional to the time convolution of the electrochemical current density, eliminating the need to calculate the latter a posteriori via numerical integration. It is demonstrated that a waveguide WE provide an optical response that can be experimentally validated by chronoamperometry and cyclic voltammetry measurements under SPP excitation for a few potassium ferricyanide (redox species) concentrations in potassium nitrate (electrolyte) and various scan rates. Cyclic voltammetry measurements taken under increasing SPP power produce a regime where SPPs no longer act solely as the probe, but also act as a pump, producing energetic electrons and holes via their absorption in the WE. The energetic carriers enhance (10×) redox current densities as well as the convolution signal measured directly as the optical output power over time.
| Identifer | oai:union.ndltd.org:uottawa.ca/oai:ruor.uottawa.ca:10393/44231 |
| Date | 04 November 2022 |
| Creators | Hirbodvash, Zohreh |
| Contributors | Berini, Pierre |
| Publisher | Université d'Ottawa / University of Ottawa |
| Source Sets | Université d’Ottawa |
| Language | English |
| Detected Language | English |
| Type | Thesis |
| Format | application/pdf |
Page generated in 0.0022 seconds