Turbines encounter blade failures due to fatigue and creep. It has been shown in the literature that the primary cause of steam turbine blade failures worldwide can be ascribed to fatigue in low pressure (LP) turbine blades. The failure and damage to these blades can lead to catastrophic consequences. Some utilities use empirical methods to determine the forces experienced by turbine blades but desire more accurate methods. The inaccurate
prediction of high-cycle fatigue (HCF), thermal durability and stage performance
is introduced when one does not consider blade row interaction. Blade row interactions can, however, be accounted for by means of computational fluid dynamics (CFD). Furthermore, modern high- fidelity CFD tools would be able to contribute greatly in predicting the forces experienced by turbine blades.
Numerical tools such as CFD and nite element analysis (FEA) can greatly contribute to the estimation of the remaining useful life (RUL) of turbine blades. However, in this estimation process, there are various uncertainties and aspects that affect the estimated RUL. Understanding the sensitivity of the estimated RUL to these various uncertainties and aspects is of great importance if RUL is to be estimated as accurately as possible.
In this dissertation, a sensitivity analysis is performed with the purpose of establishing the sensitivity of the estimated RUL of the last stage rotor of an LP steam turbine, to the number of harmonics used in a nonlinear harmonic (NLH) CFD simulation. The sensitivity of the estimated RUL is evaluated in the HCF regime, where the cyclic stresses occur below the yield strength of the turbine blade. A CFD model, FE model, and fatigue model were therefore developed in such a manner that would suffice, regarding the purpose of the sensitivity analysis. The CFD model is validated by comparing the predicted CFD power to that of actual generated power of a dual 100MW LP steam turbine. The sensitivity analysis is performed for 3 operation conditions, and for each operational condition the aerodynamic forces were computed using 1, 2, and 3 harmonics in an NLH simulation.
The estimation process considers a weak coupling between the CFD model and FE model. NLH simulations are firstly performed to calculate the unsteady static surface pressure distributions on the last stage rotor. This is followed by the mapping thereof to the FE model, for which a transient structural analysis is performed. Finally, the RUL is estimated by performing a fatigue analysis on the stress history obtained from the transient structural analysis.
Based on the results of the sensitivity analysis, the following recommendations were made, from a conservative point of view. Firstly, in general, if the RUL is to be estimated with reasonable accuracy, just using 1 harmonic in an NLH simulation will not be sufficient and 2 harmonics should be used. Secondly, if the RUL has to be estimated with high accuracy, 3 harmonics should be used. / Dissertation (MEng)--University of Pretoria, 2018. / National Research Foundation (NRF) / Mechanical and Aeronautical Engineering / MEng / Unrestricted
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:up/oai:repository.up.ac.za:2263/69152 |
| Date | January 2018 |
| Creators | Maré, Charl Francois |
| Contributors | Heyns, P.S. (Philippus Stephanus), charlfmare@gmail.com, Dunn, Dwain |
| Publisher | University of Pretoria |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Dissertation |
| Rights | © 2019 University of Pretoria. All rights reserved. The copyright in this work vests in the University of Pretoria. No part of this work may be reproduced or transmitted in any form or by any means, without the prior written permission of the University of Pretoria. |
Page generated in 0.0019 seconds