Return to search

Hot deformation mechanisms in Mg-x%Al-1%Zn-y%Mn alloys

Magnesium sheet for automotive applications is very attractive due to its light weight. The poor formability of magnesium and its alloys at room temperature, however, has limited the applications of these alloys. For this reason, at present, magnesium must be formed at elevated temperatures. This study investigates the hot deformation and fracture characteristics of Mg-1wt% Zn alloys containing a range of Al and Mn levels. Hot-rolled specimens were tensile tested over a range of strain rates and temperatures. Strain rate versus flow stress diagrams plotted on log-log scales revealed a transition in deformation mechanisms as a change in slope (the 'stress exponent'). Specifically, non-uniform deformation (i.e. necking) is observed at high strain rates, while uniform deformation is observed at low rates. This transition is accompanied by a change in fracture mechanism from dimpled rupture at high strain rates to cavitation and cavity interlinkage at low strain rates. Specimens which had a stress exponent of ∼2 and which failed through uniform deformation showing interlinked cavities have been associated with the grain boundary sliding (GBS) deformation mechanism. Specimens which had a stress exponent of ~5 and which failed through necking showing a dimpled fracture surface have been associated with the dislocation creep deformation mechanism. Increasing aluminum appears to somewhat favour the GBS regime as indicated by a slightly decreasing stress exponent. Manganese also appears to favor the GBS regime, since the onset of cavitation appears at higher strain rates compared to alloys without Mn.

Identiferoai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:QMM.100233
Date January 2006
CreatorsSeale, Geoff, 1978-
PublisherMcGill University
Source SetsLibrary and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada
LanguageEnglish
Detected LanguageEnglish
TypeElectronic Thesis or Dissertation
Formatapplication/pdf
CoverageMaster of Engineering (Department of Mining, Metals and Materials Engineering.)
Rights© Geoff Seale, 2006
Relationalephsysno: 002670482, proquestno: AAIMR38493, Theses scanned by UMI/ProQuest.

Page generated in 0.002 seconds