Return to search

Sputtering and Characterization of Complex Multi-element Coatings

The thin film technology is of great importance in modern society and is a key technology in wide spread applications from electronics and solar cells to hard protective coatings on cutting tools and diffusion barriers in food packaging. This thesis deals with various aspects of thin film processing and the aim of the work is twofold; firstly, to obtain a fundamental understanding of the sputter deposition and the reactive sputter deposition processes, and secondly, to evaluate sputter deposition of specific material systems with low friction properties and to improve their performance.From studies of the reactive sputtering process, two new methods of eliminating the problematic and undesirable hysteresis effect were found. In the first method it was demonstrated that an increased process pressure caused a reduction and, in some cases, even elimination of the hysteresis. In the second method it was shown that sufficiently high oxide content in the target will eliminate the hysteresis. Further studies of non-reactive magnetron sputtering of multi-element targets at different pressures resulted in huge pressure dependent compositional gradients over the chamber due to different gas phase scattering of the elements. This has been qualitatively known for a long time but the results presented here now enable a quantitative estimation of such effects. For example, by taking gas phase scattering into consideration during sputtering from a WS2 target it was possible to deposit WSx films with a sulphur content going from sub-stoichiometric to over-stoichiometric composition depending on the substrate position relative the target. By alloying tungsten disulphide (WS2) with carbon and titanium (W-S-C-Ti) its hardness was significantly increased due to the formation of a new titanium carbide phase (TiCxSy). The best sample increased its hardness to 18 GPa (compared to 4 GPa for the corresponding W-S-C coating) while still maintaining a low friction (µ=0.02) due to the formation of easily sheared WS2 planes in the wear track.

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:uu-229207
Date January 2014
CreatorsSärhammar, Erik
PublisherUppsala universitet, Fasta tillståndets elektronik, Uppsala
Source SetsDiVA Archive at Upsalla University
LanguageEnglish
Detected LanguageEnglish
TypeDoctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess
RelationDigital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Science and Technology, 1651-6214 ; 1162

Page generated in 0.0021 seconds