In a typical light metal building, the structural members are designed for the forces and moments obtained from the wind drift analysis, which assumes pinned connections at the base. The pinned connections provide no moment at the base and have zero rotational stiffness. However, in reality every connection provides some restraint and has some rotational stiffness. Hence, by considering a modeling assumption of pinned condition, the actual behavior of the connection is not captured and this results in overestimation of lateral drifts and appearance of larger moments at the knee of the gable frames. Since the structural components are designed on the basis of these highly conservative results, the cost of the project increases. This thesis investigates the real behavior of the column base connection and tries to reduce the above stated conservatism by developing a computer program or "wizard" to calculate the initial rotational stiffness of any column base connection.
To observe the actual behavior of a column base connection under different load cases, a number of finite element models were created in SAP2000. Each finite element model of the column base connection contained base plate, column stub, anchor bolts and in some cases grout as its components. The model was mainly subjected to three load cases, namely gravity, wind and gravity plus wind. After performing many analyses, the influence of flexibility of each component on the flexibility of the connection was observed and a list of parameters was created. These parameters are the properties of above mentioned components which characterizes any column base connection. These parameters were then used as inputs to model any configuration of the column base connection in the developed wizard. The wizard uses OpenSees and SAP2000 to analyze the modeled configuration of the connection and provides values of the initial rotational stiffness and maximum bearing pressure for the provided loads. These values can be further used in any structural analysis which is done to calculate the lateral drift of a frame under lateral loads. This will also help in getting results which are less conservative than the results which one gets on assuming pinned condition at the base. / Master of Science
Identifer | oai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/42686 |
Date | 29 May 2012 |
Creators | Verma, Amber |
Contributors | Civil Engineering, Charney, Finley A., Eatherton, Matthew R., Roberts-Wollmann, Carin L. |
Publisher | Virginia Tech |
Source Sets | Virginia Tech Theses and Dissertation |
Detected Language | English |
Type | Thesis |
Format | application/pdf |
Rights | In Copyright, http://rightsstatements.org/vocab/InC/1.0/ |
Relation | Verma_A_T_2012.pdf |
Page generated in 0.0019 seconds