Published Article / Metal injection moulding (MIM) offers advantages for mass production of components over conventional production methods for parts with complex shapes and large production runs. The MIM process includes mixing a fine metallic powder with a polymeric binder to produce a homogeneous feedstock. This enables the production of metallic components in a similar manner to plastic injection moulding. After undergoing a process of binder removal the components undergo a conventional sintering cycle. As significant shrinkage occurs (as much as 30%) this must be considered when designing the die cavity. This paper describes the design and manufacture of a die to produce tensile specimens. Extensive injection moulding trials to produce acceptable tensile components were undertaken. The complexities and possible implications of the design of a mould on the process are discussed.
The outcomes of this research will be used by the CSIR for further development and application of the MIM technology for manufacture of high value components, such as dental implants.
Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:cut/oai:ir.cut.ac.za:11462/562 |
Date | January 2010 |
Creators | Pereira, M.F.V.T., Benson, J.M., Williams, M., Chikwanda, H. |
Contributors | Central University of Technology, Free State, Bloemfontein |
Publisher | Journal for New Generation Sciences, Vol 8, Issue 2: Central University of Technology, Free State, Bloemfontein |
Source Sets | South African National ETD Portal |
Language | en_US |
Detected Language | English |
Type | Article |
Format | 1 898 608 bytes, 1 file, Application/PDF |
Rights | Central University of Technology, Free State, Bloemfontein |
Relation | Journal for New Generation Sciences;Vol 8, Issue 2 |
Page generated in 0.0013 seconds