New technologies are continuously considered for the handling and deposition of tailings. With thickened tailings only a fraction of water used conventionally reaches the disposal area, thus limiting sizes of water holding dam facilities and areas to be rehabilitated. Heat may also be recovered with direct water circulation from the thickening. Technical-economical feasibility considerations are here coupled to the Svappavaara iron ore operations by the Luossavaara-Kiirunavaara AB (LKAB) Company in northern Sweden. Local conditions here favour placement with an elevated thickener location close to the disposal area.The thickened tailings studied here have typically average particle sizes of 20 to 100 µm with maximum sizes of up to about 500 µm. The corresponding slurries cover an intermediate area between homogeneously and heterogeneously flowing mixtures. Various design features are often refereed to in rheological terms, i.e. homogeneous flow. Here, these terms are considered with some caution due to the notable amount of particles larger than about 40 µm.The objective is to form a background for feasibility considerations based on laboratory and pilot-scale experiments in pipelines and flumes together with viscometric measurements and depositional slope observations. Pipeline diameters covered the full-scale range, up to 0.15 m.It was found that a solids concentration by volume of about 48 % characterizes the pipeline pumping, here estimated to be on the conservative side with respect to thickened product quality requirement. The overall pipeline loop results were evaluated in terms of a representative pipe wall stress of about 200 Pa. Approximate values of the Bingham yield stress and plastic viscosity were estimated to 185 Pa and 0.03 Pas, respectively. Depositional slopes have been estimated to about 4 % for slurry properties that gives a conceptually even inclination with no segregation of particles and virtually no drainage of water.With an elevated thickener location close to the disposal area a new high pressure pumping system for about 10 MPa is avoided while the thickener underflow slurry is delivered with a centrifugal pump a short distance during the first years of operation. In order to meet the most effective long-term solution for pipeline distribution and placement, continued use of centrifugal pumps in series installations is considered as the discharge point advances during the 20-year life.The performance of a centrifugal pump is affected when handling highly concentrated slurries which shows up as reductions of the clear water head and efficiency curves. It was found that maximum reductions in head and efficiency were about 10 and 15 %, respectively, when operating at the design flow rate, QBEP, in the best efficiency region. As opposed to Newtonian fluids, a diverging tendency from the water head curve for decreasing flow rates has sometimes been reported below about 0.5QBEP for slurries that show a highly non-Newtonian behaviour. Various mechanisms related to the diverging tendency are discussed. The suction side pressure requirement is normally fulfilled with a large margin for a thickener underflow pump. It was observed in an installation how a standard pump operating at 0.5QBEP under a thickener showed no unstable head tendencies for a tailings slurry with an yield stress of nearly 200 Pa. However, pumps in series installation should be arranged with sufficient margins for an increased suction side pressure requirement.Keywords: Tailings slurry, highly concentrated, non-Newtonian behaviour, centrifugal pump performance, tailings depositional conditions.
Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:ltu-17214 |
Date | January 2010 |
Creators | Wennberg, Thord |
Publisher | Luleå tekniska universitet, Institutionen för samhällsbyggnad och naturresurser, Luleå |
Source Sets | DiVA Archive at Upsalla University |
Language | English |
Detected Language | English |
Type | Licentiate thesis, comprehensive summary, info:eu-repo/semantics/masterThesis, text |
Format | application/pdf |
Rights | info:eu-repo/semantics/openAccess |
Relation | Licentiate thesis / Luleå University of Technology, 1402-1757 |
Page generated in 0.0015 seconds