The reduction of fuel consumption and carbon dioxide emissions are currently a key factor for the aviation industry due to major concerns about climate change and more restrictive environmental laws. One way to reduce both fuel consumption and CO2 emissions is by significantly decreasing the vehicle’s weight while increasing engine's efficiency. In order to meet these requirements, the European aero engine industry is continuously focusing on alternative manufacturing methods for load carrying structures in advanced materials, such as titanium and nickel-based superalloys. Alternatively to traditional large-scale single castings, new manufacturing methods involve sheet metal parts, small castings and forgings assembled by welding. These new manufacturing methods allow more flexible designs in which each part is made of the most suitable material state, leading to several advantages such as reduction of product cost and weight while increasing engine's efficiency. Nickel-based superalloys are widely used in the aero engine industry, typically constituting up to 50% of the total weight of the aircraft engine. Due to their excellent material properties at high temperatures in severe corrosive environments, these superalloys are employed most extensively in the hot sections of gas turbine engines for both military and civil aircrafts with running temperatures up to 650°C. In this thesis, a manufacturing process chain including forming and welding in the nickelbased superalloy 718 is studied. The main focus in the work lies on determining the thermomechanical properties, modelling and simulation of cold forming, study forming limits based on Nakazima tests for forming limit curves (FLC) and applying a damage and failure criterion. The work also comprises a brief study on hot forming. Finally, modelling of a subsequent welding procedure is included where residual stresses from the forming simulation are used to predict shape distortions due to the welding procedure. The results are compared with experimental observations. The cold forming procedure of a double-curved component made of alloy 718 is studied using FE-analyses and forming tests. The same geometry was used to produce a hot forming tool. During forming tests at room temperature, micro cracks and open cracks were observed in the draw bead regions, not indicated when formability is assessed using a forming limit curve (FLC). Standard material models such as von Mises or Barlat Yld2000-2D were not capable of accurately predict the behaviour of the material after the point of diffuse necking, making the prediction of damage and failure during forming a challenge. The GISSMO damage model was therefore calibrated and used to predict material failure in forming of alloy 718. Tensile, plane strain, shear and biaxial tests at room temperature are performed up to fracture and continuously evaluated using Digital Image Correlation (DIC) by ARAMIS™. In this work, the GISSMO damage model is coupled with the anisotropic Barlat Yld2000-2D material model for forming simulations in alloy 718 at room temperature using LS-DYNA. Numerical predictions are able to accurately predict failure on the same regions as observed during the experimental forming tests. Comparisons of the distribution of damage on one of the draw beads between simulations and damage measurements by acoustic emission indicate that higher damage values correspond to bigger micro cracks. Numerical FE-predictions of the cold forming and subsequent welding procedure shows that the welding procedure further increases the shape distortions. This was found to agree with experimental observations. / Virtuell processkedja för plåtformade flygmotorstrukturer i superlegeringar – Validering och demonstrator
Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:ltu-62901 |
Date | January 2017 |
Creators | Pérez Caro, Lluís |
Publisher | Luleå tekniska universitet, Material- och solidmekanik, Swerea IVF AB, Luleå |
Source Sets | DiVA Archive at Upsalla University |
Language | English |
Detected Language | English |
Type | Licentiate thesis, comprehensive summary, info:eu-repo/semantics/masterThesis, text |
Format | application/pdf |
Rights | info:eu-repo/semantics/openAccess |
Relation | Licentiate thesis / Luleå University of Technology, 1402-1757 |
Page generated in 0.0026 seconds