Contractors and tunnelling engineers consistently seek to identify techniques and equipment to improve the efficiency and lower the cost of tunnelling projects. Based on the recent successes of rock slope characterization with laser scanning techniques, the author proposes 3D laser scanning (LiDAR) as a new tool for geotechnical assessment in drill and blast tunnels.
It has been demonstrated that practical deployment of a phase-based LiDAR system at the face of an active tunnel heading is possible with a simple tripod setup. With data collection requiring only 5 minutes at the tunnel face, it was shown that this technique could be integrated into geotechnical evaluation without interruption of the excavation cycle. Following the successful scanning at two active tunnelling projects and two completed unlined tunnels, the research explored the applications of the data. With detailed geometric data of the heading as it advanced, the author identified applications of interest to the contractor/on-site engineer as well as the geotechnical engineer or geologist responsible for rockmass characterization. Operational applications included the extraction of information about tunnel geometry and installed support, while geomechanical information provided important elements of rockmass characterization. Building on the success of retrieving joint network information, the research investigated the potential for LiDAR-derived structural databases to be the basis for highly-representative 3D discrete element models. These representative models were found to be useful for back-analysis or as predictive tools for future tunnel design.
The primary implications of the thesis are that a) LiDAR data collection at the face of a drill and blast tunnel operation is practical and potentially has great value, b) data extraction is possible for a wide range of applications, and c) that discontinuum stability analysis becomes a much more powerful tool with the integration of LiDAR data. The cumulative result of the work presented is a proposed workflow for integrating LiDAR into tunneling operations. / Thesis (Master, Geological Sciences & Geological Engineering) -- Queen's University, 2010-09-22 19:38:49.401
Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OKQ.1974/6072 |
Date | 23 September 2010 |
Creators | Fekete, Stephanie |
Contributors | Queen's University (Kingston, Ont.). Theses (Queen's University (Kingston, Ont.)) |
Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
Language | English, English |
Detected Language | English |
Type | Thesis |
Rights | This publication is made available by the authority of the copyright owner solely for the purpose of private study and research and may not be copied or reproduced except as permitted by the copyright laws without written authority from the copyright owner. |
Relation | Canadian theses |
Page generated in 0.0016 seconds