A research report submitted to the Faculty of Engineering and the Built Environment,
University of the Witwatersrand, Johannesburg, in partial ful lment of the
requirements for the degree of Master of Science in Engineering.
Johannesburg, 2015 / Control of systems are important in most industrial sectors, they nd applications
in electronics, machine design and navigation. These control systems often use
sensors to work e ectively. One such sensor is an accelerometer, which is used to
measure acceleration with one or more degrees of freedom. This research report
investigates the modelling, system identi cation and controller design for an accelerometer,
a Fibre Optic Accelerometer (FOA). Such a device may be applied
in many applications such as anti-skid control, structural failure in buildings and
bridges, as well as strategic missile guidance. This report presents a model of a
FOA demonstrator which crudely models an industrially developed accelerometer,
the demonstrator is made of a jig consisting of a guitar string and electromagnets.
Such a model needs to account for a distributed parameter beam combined
with a permanent magnet and four electromagnets. The guitar string is modelled
using three beam models, namely a spring/damper model, an Assumed Modes
Model (ASM) and a Transfer Function Model (TFM). The parameters for these
beam models are identi ed using the Nelder-Mead simplex algorithm and the least
squares method. The electromagnets within the jig, are modelled using a mathematical
model obtained through curve tting of experimental data. The overall
FOA sensor is optimised using a lead-lag controller. Five cost functions where
investigated, these cost functions are H1, Integral Square Error (ISE), Integral
Absolute Error (IAE), Integral Time Square Error (ITSE) and Integral Absolute
Time Error (IATE). It was found that the guitar string may be modelled using a
single degree of freedom beam model. This is based on a number of reasons, such
as the aperture size - through which the tip Light Emitting Diode (LED) projects,
the tip mass (permanent magnet) - acting as a natural damper and the fact that
Position Sensing Device (PSD) only measures the tip position. It was found that
a single degree of freedom model in two orthogonal axes, with a single link beam
spring/damper model was the most suitable representation of the guitar string.
And the IAE lead-lag controller was found to be the most e ective in controlling
a guitar string, this e ectiveness was due to least settling time. / MT2017
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:wits/oai:wiredspace.wits.ac.za:10539/22655 |
| Date | January 2015 |
| Creators | Cornelius, Justin Calen |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Thesis |
| Format | Online resource (197 leaves), application/pdf, application/pdf |
Page generated in 0.0019 seconds