Pulmonary and oral drug administrations are usually the preferred methods of delivery of active pharmaceutical ingredients.Generally,pulmonary drug formulations are more attractive compared to oral formulations since they consist of micron-sized powders with high surface area thus having faster onset of action,as well as minimizing the drug dosage and side effects.Oral insulin formulations,if achievable,would provide an alternative to injectable insulin,as the common drawbacks of injectable insulin are the multiple daily injections and the possibility of skin infections at the injection site. In this study,the feasibility of using dense gas particle processing techniques known as the Aerosol Solvent Extraction System (ASES),Gas Anti-Solvent (GAS)and High-Pressure Media Milling (HPMM)for pharmaceutical processing was assessed.The ASEStechnique,utilizing dense ethane,was employed to prepare insulin-lactose formulations for pulmonary administration whilst the GAS and ASES techniques,utilizing dense CO2,were employed to prepare microencapsulated formulations containing insulin and Eudragit?? S100 for oral administration.Furthermore,the HPMM technique,utilizing dense hydrofluocarbon (HFC)134a/227ea,was employed to prepare suspension Metered Dose Inhaler (MDI)formulations containing budesonide and various surfactants. The Fine Particle Fraction (FPF)of processed insulin without the presence of lactose was found to be 44%.In other words,44% of processed insulin delivered to the impactor stages (excluding the throat and neck)has aerodynamic diameter of less than 5??m.With the addition of lactose as carrier,the FPFof the insulin-lactose (1:1w/w)formulation increased to 64%.The increase in FPFwas attributed to the lower density of lactose particles compared to that of insulin particles to produce an intimate mixture with enhanced powder flowability and aerodynamic performance. Proteins for oral delivery should ideally be formulated with acid-resistant polymer as a protective coating to protect against enzymatic degradation in the stomach.Eudragit?? S100,which is insoluble or almost impermeable at pH 1-4and soluble at pH 5-7,was used to prepare oral insulin formulations.The insulin release at pH 3was sustained by the Eudragit?? S100coating and the encapsulation efficiency of insulin??Eudragit?? S100formulations varied between 6% and 24% depending on the initial drug to polymer ratio. One of the major therapies utilizing metered dose inhaler formulations in the treatment of asthma has been studied using the HPMM process.The HPMM process has been demonstrated to be an efficient milling process for the enhancement of the physical stability and aerodynamic performance of budesonide in HFC-134a/227ea propellant formulations.No significant change in physical stability was observed in the formulations for 2 weeks.
| Identifer | oai:union.ndltd.org:ADTP/257145 |
| Date | January 2006 |
| Creators | Tandya, Andrian, Chemical Sciences & Engineering, Faculty of Engineering, UNSW |
| Publisher | Awarded by:University of New South Wales. School of Chemical Sciences and Engineering |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | Copyright Andrian Tandya, http://unsworks.unsw.edu.au/copyright |
Page generated in 0.0019 seconds