The main topic of this thesis is a catalytic oxidation which belongs to a group of modern technologies for removing emission of CO and VOC from waste air. In the introduction of this thesis, the basic concepts are defined. Further the legislative requirements associated with VOC emissions, emission limits and conditions are summarized. Described destructive and non-destructive methods for removing VOCs from waste gases are also briefly described. Increased attention is paid to the catalytic oxidation as the main theme of the thesis. It was searched for industrial applications where the catalytic oxidation is used. Another chapter is devoted to the theoretical analysis of kinetics of catalytic oxidation reactions. Firstly, the basic types of reactors are described and also material balance and reaction rate for the isothermal and adiabatic reactor. In the experimental part results of performed kinetic measurements on a pilot unit for catalytic commonly used organic solvents (VOCs) using commercially available catalysts were summarized. Pre-exponential factors and activation energies for sprinkling catalysts EnviCat VOC-5565 and EnviCat 55068 for substances ethanol, toluene and acetone were determined. "Light-off" curves for these substances and methane were measured and on sprinkled catalyst EnviCat 55068 and on monolithic catalyst Purelyst PH-304.
| Identifer | oai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:241878 |
| Date | January 2016 |
| Creators | Osička, Tomáš |
| Contributors | Jecha, David, Brummer, Vladimír |
| Publisher | Vysoké učení technické v Brně. Fakulta strojního inženýrství |
| Source Sets | Czech ETDs |
| Language | Czech |
| Detected Language | English |
| Type | info:eu-repo/semantics/masterThesis |
| Rights | info:eu-repo/semantics/restrictedAccess |
Page generated in 0.0017 seconds