In order to meet the requests of the application as pixel switch and current driver in next generation active-matrix liquid crystal displays (AMLCD) and active-matrix organic light-emitting diodes (AMOLED). The materials of low temperature poly-silicon (LTPS) and metal-oxide are supposed to be the most potential material for active layer of thin-film transistors (TFTs) due to their high mobility compared to the traditional amorphous silicon TFTs. Therefore, in order to make the LTPS TFTs and metal-oxide TFTs affordable for the practical applications, the understanding of instability and reliability is critically important.
In the first part, we studied the nonvolatile memory characteristics of polycrystalline-silicon thin-film-transistors (poly-Si TFTs) with a silicon-oxide-nitride-oxide-silicon (SONOS) structure. As the device was programmed, significant gate induced drain leakage current was observed due to the extra programmed electrons trapped in the nitride layer which. In order to suppress the leakage current and thereby avoid signal misidentification, we utilized band-to-band hot hole injection method to counteract programmed electrons and this method can exhibit good sustainability because the injected hot holes can remain in the nitride layer after repeated operations. On the other hand, we also investigated the degradation behavior of SONOS-TFT under off-state stress. After the electrical stress, the significant on-state degradation indicates that the interface states accompanied with hot-hole injection. Moreover, the ISE-TCAD simulation tool was utilized to model the degradation mechanism and analyze trap states distribution. Furthermore, we also performed the identical off-state stress for the device with different memory states. The different degradation behavior under different memory states is attributed to the different overlap region of injected holes and trap states.
In the second part, the degradation mechanism of indium-gallium-zinc oxide (IGZO) thin film transistors (TFTs) caused by gate-bias stress performed in the dark and light illumination was investigated. The parallel threshold voltage indicates that charge trapping model dominates the degradation behavior under positive gate-bias stress. However, the degradation of negative gate bias stress is much slighter than the positive gate bias stress since the IGZO material is hard to induced hole inversion layer. In addition, the hole mobility is much lower than electron resulting in ignorable hole trapping effect. On the other hand, the identical positive and negative gate bias stress performed under light illumination exhibit opposite degradation behavior compared with dark stress. This degradation variation under dark and light illumination can be attributed to the effectively energy barrier variation of electron and hole trapping. Furthermore, to further investigate the light induced instability for IGZO TFTs, the device with and without a SiOx passivation were investigated under light illumination. The experiment results indicate that oxygen adsorption and desorption dominate the light induced instability for unpassivated device and the trap states caused during the passivation layer deposition process will induce apparent subthreshold photo-leakage current under light illumination.
In the third part, we investigated the degradation mechanism of IGZO TFTs under hot-carrier and self-heating stress. Under hot-carrier stress, except the electron trapping induced positive Vt shift, an apparent on-current degradation behavior indicates that trap states creation. On the other hand, the identical hot-carrier stress performed in the asymmetric source/drain structure exhibits different degradation behavior compared with symmetric source/drain structure. For asymmetric structure, the strong electrical field in the I-shaped drain electrode will induce channel hot electron injection near the drain side and cause asymmetric threshold voltage degradation. In this part we also investigated the degradation behavior under self-heating stress. The apparent positive threshold voltage (Vt) shift and on-current degradation indicate that the combination of trap states generation and electron trapping effect occur during stress. The trap states generation is caused by the combination of Joule heating and the large vertical field. Moreover, the Joule heating generated by self-heating operation can enhance electron trapping effect and cause larger Vt shift in comparison with the gate-bias stress.
Finally, the electrical properties and photo sensitivity of dual gate IGZO TFTs were investigated. The asymmetric electrical properties and photo sensitivity under top gate and bottom gate operation is attributed to the variation of gate control region. Furthermore, the obvious asymmetric photo sensitivity can be utilized to the In-cell touch panel technology and lower the process cost compared with the traditional a-Si TFTs due to the elimination of black matrix.
| Identifer | oai:union.ndltd.org:NSYSU/oai:NSYSU:etd-0702112-123925 |
| Date | 02 July 2012 |
| Creators | Chen, Te-Chih |
| Contributors | HSU,CHENG-TSUNG, HUANG,CHENG-TUNG, CHENG,TZU-MING, CHANG,TING-CHANG, TSAI,TSUNG-MING |
| Publisher | NSYSU |
| Source Sets | NSYSU Electronic Thesis and Dissertation Archive |
| Language | English |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://etd.lib.nsysu.edu.tw/ETD-db/ETD-search/view_etd?URN=etd-0702112-123925 |
| Rights | unrestricted, Copyright information available at source archive |
Page generated in 0.004 seconds