The objective of this project was to develop blends based upon post consumer RPET and N6, and to evaluate the suitability of these blends to form fibres for the end use in carpet fibre.
In the work carried out it was found it is possible to spin RPET/N6 biconstituent fibres over a wide range of blend ratios. All the blends studied have diminished physical properties when compared to those of pure RPET and N6. The processability of these blends also deteriorated due to the large increases in normal forces which manifests in extrusion equipment as die swell that often results in melt fracture.
It has been shown that the morphology of the fibre controls the degree of decay in properties and die swell at the spinnerette. The blends that are rich in one phase, with the secondary phase distributed as elongated fibrils have shown better physical performance and improved processing compared to the blends 70/30 � 30/70, which have poorer properties and increased die swell due to there co-continuous morphology. In quiescent studies, the physical properties of the blends have had little deviation from those predicted using a rule of mixtures line. In and around the 50% RPET blend, die swell was observed to be extreme and this makes fibre spinning difficult. It was found that this was caused by a loss in viscosity in the blends and a general increase in normal forces in response to applied shear. The die swell phenomenon is a rheological characteristic of the blends, which was inevitably caused by internal capillary flow of one component in the other.
IR spectroscopy has shown that there is little to no in-situ compatibilisation occurring during simple melt processing. However, it was found that significant interfacial compatibilisation could be achieved through solid stating N6/RPET blends. The FTIR spectra for solid state blends in figure 4.51 has shown absorbency in the 3300 cm-1 region after all free N6 was removed. This indicates that in-situ compatibilisation has occurred between the phases in the solid stating process and it is a time dependent reaction.
The Burgers and Koltunov models can be used to predict the creep behaviour of the fibre blends studied. The Burgers model provides greater accuracy for longer-term exposure to stress.
From the thermal results, the solid stating process significantly affects the melting and crystallisation out of the melt and the ultimate level of crystallinity. The contribution of the copolymer in these changes appears to be small. The physical strength of the fibres made on the laboratory line was only marginally lower than those made on a factory line. The morphology of the mid-range blends is co-continuous and that of the N6 and RPET rich blends is dispersed droplet morphology.
Based on the finding, a N6 rich blends and in particular the 10% RPET blend is the most suitable for further commercial development as its processing, physical performance and post spinning processing closely resemble the pure N6 currently in use. It has provided performance and consistency throughout the processing and testing we have conducted.
| Identifer | oai:union.ndltd.org:ADTP/216638 |
| Date | January 2006 |
| Creators | Kegel, Mark Steven, n/a |
| Publisher | Swinburne University of Technology. |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://www.swin.edu.au/), Copyright Mark Steven Kegel |
Page generated in 0.0018 seconds