Return to search

Plasma-induced modification of films containing polytetrafluoroethylene (PTFE)

Polymer samples of polytetrafluoroethylene (PTFE) and a PTFE-glass weave (RF-
35P) are exposed to low pressure, non-equilibrium glow discharge plasmas for
enhanced wettability as measured by static contact angles. Plasma treatments are
performed in two parallel plate RF plasma systems, a downstream microwave plasma
and a barrel etcher using feed gases composed of H₂, N₂, Ar, He, and 0₂. Surface
analysis of the topography and chemical composition of treated samples is performed
by atomic force microscopy (AFM), attenuated total reflection infrared (ATR-IR)
spectroscopy, x-ray photoelectron spectroscopy (XPS) and time-of-flight secondary
ion mass spectroscopy (ToF SIMS). Optical emission spectroscopy is used to correlate
wettability to reactive species in the plasma, and plasma parameters to species
emission.
In the parallel plate plasma systems, the contact angle can change from
approximately 95° to 5° with treatment while treatments in the downstream and barrel
etcher systems do not result in a contact angle change. The difference in plasma
performance is attributed to ion bombardment. Plasmas composed of 20 to 80% H₂O in
(H₂ + N₂) give the best wettability improvement. Plasma exposure significantly
reduces the surface fluorine content followed by incorporation of nitrogen, oxygen and
hydrogen, apparently as amino, hydroxyl and carbonyl functional groups with
evidence of an amide. The incorporation of oxygen likely originates through peroxy
radicals subsequent to plasma exposure. It is proposed that using a higher applied
power creates a more reactive surface. A larger percentage of H₂ in the plasma tends
to passivate the surface, leading to a smaller wettability improvement which is
correlated to the atomic hydrogen concentration in the plasma. The addition of He or
Ar into the H₂/N₂ plasma tends to dilute or weaken the plasma effect on wettability.
To a much greater extent, the addition of oxygen also decreases the wettability. This
latter effect is attributed to etching reactions which result in a more hydrophobic
surface. An etch rate of approximately 0.2 μ/min is observed, and this is the first
report of PTFE etching with 0₂/H₂/N₂. The distance between the parallel plate
electrodes (gap) is a significant factor for the wettability of treated polymers, while
power, pressure and flow rate are not. The optimal storage conditions to retain the
wettability of H₂/N₂ plasma-treated RF-35P are low pressure and low temperature.
The following model of PTFE surface modification is proposed. Ion bombardment
creates reactive sites that initiate surface reactions. Reactive species from the H₂/N₂
plasma modify the surface through incorporation of amino, hydroxyl and carbonyl
surface groups. These new groups increase the polymer wettability. Atomic hydrogen
in the mixture is required to improve the wettability, but too high of a concentration
will passivate the surface and lessen the wettability improvement. If oxygen is present,
the modified surface is etched away leaving a refreshed, more hydrophobic surface. / Graduation date:2006

Identiferoai:union.ndltd.org:ORGSU/oai:ir.library.oregonstate.edu:1957/29169
Date08 June 2005
CreatorsJones, Hyrum E.
ContributorsKoretsky, Milo D.
Source SetsOregon State University
Languageen_US
Detected LanguageEnglish
TypeThesis/Dissertation

Page generated in 0.002 seconds