M.Ing. / In this investigation charge balancing will be investigated from an Electro-Magnetic- Compatibility perspective. The primary sources of common mode Electro-Magnetic- Interference in switching converters are the switching nodes. This is mainly due to the parasitic capacitance between the switching node and the reference earth. Filtering components that are currently used take up a lot of valuable space resulting in the products overall size and cost to increase. Combating common mode current at the source will drastically reduce the size or the need for these large filters. This investigation will focus on a simple method of reducing common mode noise (produced by the switching node), of a two wire system, at the source by making use of a compensating winding which requires very little or no additional space; a buck converter will be used to illustrate the concept. The investigation will start with an overview of Electro-Magnetic-Interference and its components (common and differential mode noise). This investigation will deal with the measurement of common and differential mode noise as well as general Electro-Magnetic-Interference measurement. A design of the buck converter and its drive circuit will also be presented. Reducing the common mode noise by making use of charge balancing using planar inductors will then be presented. This investigation contains the theoretical analysis as well as experimental results to validate the theory. The experiments show encouraging results in using this technique to minimise common mode noise in switched-mode-power-supplies.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:uj/uj:8150 |
| Date | 26 February 2009 |
| Source Sets | South African National ETD Portal |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.002 seconds