In recent years, the automotive industry has turned to press hardened steels (PHS) to improve passenger safety while enabling vehicle weight reduction. To form the complex shapes required for this purpose, they are often direct hot press formed. It is possible to provide corrosion resistance to these parts by galvanizing the PHS sheets prior to direct hot press forming (DHPF). However, the austenitization of the galvanized steel causes the Zn-based coating to transform into two intermetallic phases. These are iron-rich α-Fe(Zn) and zinc-rich Г-Fe3Zn10. The Г-Fe3Zn10 is liquid during traditional DHPF, and the applied stress can result in liquid metal embrittlement (LME). Recently, two new grades of PHS have been developed, which allow for DHPF at 600-700°C, below the Fe-Zn peritectic temperature at 782°C, thus avoiding LME. These prototype PHS grades are designated 2%Mn (0.2C-2Mn-0.25Si-0.005B (wt%)) and 2.5%Mn (0.2C-2.5Mn-0.25Si-0.005B (wt%)). The objective of this work is to determine the effect of DHPF on the ability of a Zn-based coating to provide robust cathodic protection to the two prototype PHS.
Galvanized panels of both the 2%Mn and 2.5%Mn steel were DHPF with a U-shape die at 700°C. The surface and cross-section of the coating were examined to determine the effects of DHPF on the coating surface. Die friction during DHPF resulted in die wiping on the wall of the part, leading to removal of surface Г-Fe3Zn10. In cross-section, coating cracks were present at the wall and corner of the U-shape part due to the deformation during DHPF. Potentiodynamic polarization scans were used to determine the corrosion potential of the coating, and this was used to calculate the driving force for cathodic protection using the difference in corrosion potential between the coating phases and the substrate. It was found that only Γ-Fe3Zn10 provided robust cathodic protection to both steel substrates, and the driving force for cathodic protection was lower for the coated DHPF 2.5%Mn steel. Galvanostatic scans were used to evaluate dissolution kinetics of coating phases. Robust cathodic protection was provided by the galvanized coating for austenitization times of 30 - 120 s for the 2%Mn substrate and 30 - 60 s for the 2.5%Mn substrate. The duration that robust cathodic protection was provided was shortest at the wall of the U-shape part.
This result was attributed to die wiping caused by DHPF, where the surface is smoothed by die friction. When there is less Г-Fe3Zn10 in the coating, such as at longer austenization times, surface Г-Fe3Zn10 was removed and an increased amount of α-Fe(Zn) is exposed, which does not provide robust cathodic protection. In addition, coating cracks form along α-Fe(Zn) grain boundaries after austenitization for 180 s on all examined regions of the U-shape part, allowing a greater surface area of the coating exposed to electrolyte, further increasing dissolution of the coating. / Thesis / Master of Applied Science (MASc)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/26696 |
| Date | January 2021 |
| Creators | Jewer, Jaime |
| Contributors | McDermid, Joseph, Kish, Joseph, Materials Science and Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0019 seconds