This thesis describes a further development of an existing prototype named Automatic pin bone remover. The further development was requested from the Swedish consulting firm ATM AB. The request of automatic pin bone removers is high and has the potential to be a worldwide leading product. The goal with the thesis work is to further develop an existing prototype. In order to achieve the goal a pre-study of the prototype had to be made in order to define a customer demand specification. The thesis work is then continued by a function analysis which differs from a conservative one. For each sub-function various sub solutions a made. The advantage of this method is that it results in various total solutions which after an evaluation one will be chosen for further development. To examine if the fully developed prototype achieved the given demands a test specification was made. The tests resulted in success, however later in the thesis it is recommended to perform tests on a real prototype to ensure that the given demands are fulfilled. These tests however are not a part of this thesis. The economic sub goal with the thesis was not properly fulfilled, however the remaining goals was fulfilled successfully. The result of the thesis was an improved prototype, manufacturing documentation of the prototype and a suggestion of material change that could lead to reduced total costs.
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:uu-176600 |
| Date | January 2012 |
| Creators | Tanco Villaverde, André, Hajima, Izhar Jeffrey |
| Publisher | Uppsala universitet, Institutionen för teknikvetenskaper, Uppsala universitet, Institutionen för teknikvetenskaper |
| Source Sets | DiVA Archive at Upsalla University |
| Language | Swedish |
| Detected Language | English |
| Type | Student thesis, info:eu-repo/semantics/bachelorThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
Page generated in 0.0018 seconds