Return to search

Bond Performance between Corroded Steel and Recycled Aggregate Concrete Incorporating Nano Silica

The current research project mainly aims to investigate the corrosion resistance and bond
performance of steel reinforced recycled aggregate concrete incorporating nano-silica under
both normal and corrosive environmental conditions. The experimental part includes testing
of 180 pull-out specimens prepared from 12 different mixtures. The main parameters studied
were the amount of recycled aggregate (RCA) (i.e. 0%, 25%, 50% and 100%), nano silica
(1.5% and 3%), steel embedment length as well as steel bar diameter (12 and 20mm).
Different levels of corrosion were electrochemically induced by applying impressed voltage
technique for 2, 5, 10 and 15 days. The experimental observations mainly focused on the
corrosion level in addition to the ultimate bond, failure modes and slips occurred.
Experimental results showed that the bond performance between un-corroded steel and
recycled aggregate concrete slightly reduced, while a significant degradation was observed
after being exposed to corrosive conditions, in comparison to normal concrete. On the other
hand, the use of nano silica (NS) showed a reasonable bond enhancement with both normal
and RCA concretes under normal conditions. However, much better influence in terms of bond
and corrosion resistance was observed under advancing levels of corrosion exposure,
reflecting the improvement in corrosion resistance. Therefore, NS was superbly effective in
recovering the poor performance in bond for RCA concretes. More efficiency was reported
with RCA concretes compared to the conventional concrete. The bond resistance slightly with
a small amount of corrosion (almost 2% weight loss), then a significant bond degradation
occurs with further corrosion.
The influence of specific surface area and amount of nano silica on the performance of concrete
with different water/binder (w/b) ratios has been also studied, using 63 different mixtures produced
with three different types of colloidal NS having various surface areas and particle sizes. The
results showed that the performance of concrete is heavily influenced by changing the surface area
of nano silica. Amongst the three used types of nano silica, NS with SSA of 250 m2
/g achieved the highest enhancement rate in terms of compressive strength, water absorption and
microstructure analysis, followed by NS with SSA of 500 m2/g, whilst NS with SSA of 51.4
m2
/g was less advantageous for all mixtures. The optimum nano silica ratio in concrete is
affected by its particle size as well as water to binder ratio.
The feasibility of the impact-echo method for identifying the corrosion was evaluated and
compared to the corrosion obtained by mass loss method. The results showed that the impact echo testing can be effectively used to qualitatively detect the damage caused by corrosion in
reinforced concrete structures. A significant difference in the dominant frequencies response
was observed after exposure to the high and moderate levels of corrosion, whilst no clear
trend was observed at the initial stage of corrosion.
Artificial neural network models were also developed to predict bond strength for corroded/uncorroded steel bars in concrete using the main influencing parameters (i.e., concrete strength,
concrete cover, bar diameter, embedment length and corrosion rate). The developed models
were able to predict the bond strength with a high level of accuracy, which was confirmed by
conducting a parametric study. / Higher Education Institute of the Libyan Government

Identiferoai:union.ndltd.org:BRADFORD/oai:bradscholars.brad.ac.uk:10454/19086
Date January 2020
CreatorsAlhawat, Musab M.
ContributorsAshour, Ashraf F.
PublisherUniversity of Bradford, Faculty of Engineering and Informatics
Source SetsBradford Scholars
LanguageEnglish
Detected LanguageEnglish
TypeThesis, doctoral, PhD
Rights<a rel="license" href="http://creativecommons.org/licenses/by-nc-nd/3.0/"><img alt="Creative Commons License" style="border-width:0" src="http://i.creativecommons.org/l/by-nc-nd/3.0/88x31.png" /></a><br />The University of Bradford theses are licenced under a <a rel="license" href="http://creativecommons.org/licenses/by-nc-nd/3.0/">Creative Commons Licence</a>.

Page generated in 0.0029 seconds