Friction in machining is a complex phenomenon that can directly affect cutting productivity and product quality. Currently, different coatings are developed for machining applications which can increase tool life in the machining processes. Since performing a real machining test to quantify the friction is expensive and time-consuming, developing a bench scale testing method to simulate the friction in machining can reduce the cost and help researchers and industries select a suitable coating for their specific applications.
The goal of this work was to study the adhesion between the tool and workpiece material under machining conditions by simulating them using a heavy-load high-temperature tribometer. A high normal load was applied to plastically deform the workpiece material. The contact zone was then heated up using a resistance heating method. The normal load should be in the range that can generate a plastic flow on the surface of the workpiece material prior to seizure.
Three groups of in-house coatings were tested to study the effects of coating deposition parameters on the coefficient of friction. The results of these tests showed that the coating with the lowest bias voltage and highest Nitrogen pressure had the best tribological performance.
As a next step, three different commercial coatings were selected. Super duplex stainless steel was chosen as the workpiece material and the tribometer tests were performed. To validate the tribometer results real machining tests and tool wear analysis were performed. AlTiNOS+ WC/C was observed to be a lubricious coating which reduced the cutting force and coefficient of friction during the running-in stage. However, the low hardness of the coating provided little abrasion resistance and was removed after the first pass. AlTiNOS+ TiB2 demonstrated a good combination of hardness and lubricity associated with improved coating tribological performance as well as wear resistance. / Thesis / Master of Applied Science (MASc)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/24580 |
| Date | January 2019 |
| Creators | Aliakbari Khoei, Ali |
| Contributors | Veldhuis, Stephen, Mechanical Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0019 seconds