This thesis reports original work on digital compensation for frequency dependent transfer characteristics and errors in digital PAM/CPFSK (Pulse Amplitude Modulation/Continuous Phase Frequency Shift Keying) quadrature modulators.A particularly flexible and cost effective approach to the implementation of the base-band section of a radio transmitter is to synthesise base-band signals digitally using a DSP (Digital Signal Processor). This approach is limited, however, by the transfer characteristics and errors in the implementation of practical analogue sub-systems. These practical limitations result in undesirable in-band frequency-dependent shaping of the transmitted signals. In the case of FM (Frequency Modulation) signals, this leads to the generation of unwanted side-lobes in the transmitted RF signal spectrum that interfere with signals in adjacent frequency channels. This results in the transmitted signal failing to meet transmission standards requirements.The digital compensation techniques developed and presented in this thesis allow the reduction of undesirable in-band frequency-dependent signal shaping. It is shown that this enables strict requirements on the spectral emissions from the FM transmitter to be met using a flexible and cost effective DSP based modulator system.The contributions of the thesis are in three primary areas:(i) The development of a structure for frequency dependent digital compensation.(ii) The formulation and solution of an optimisation problem that allows the free parameters within the structure to be determined such that effective reduction of unwanted in-band frequency-dependent signal shaping is achieved.(iii) The development of techniques that allow the digital compensation procedure to be successfully implemented on a practical DSP platform.The new digital compensation structure that is proposed uses two digital FIR (Finite ++ / Impulse Response) filters in the digital base-band section of the quadrature modulator: one in the in-phase (I) channel and one in the quadrature (Q) channel. The tap-weights of the FIR filters are determined by solving two optimisation problems: one for each channel. The optimisation problems are formulated using a new approach that ensures that the degrees of freedom in the optimisation i.e., the FIR filter tap-weights, are used effectively to meet the objective of reducing in-band frequency-dependent signal shaping in analogue sub-systems further down the transmission path.A characterisation of the solutions to the optimisation problems enables the identification of techniques that need to be adopted to successfully implement the proposed digital compensation on a practical DSP-based system.The digital compensation technique is demonstrated by implementing and testing the technique on a DSP platform. The results of experimental studies are presented which clearly demonstrate that the digital compensation technique leads to substantial reductions in adjacent channel interference.
| Identifer | oai:union.ndltd.org:ADTP/222549 |
| Date | January 2000 |
| Creators | Tuthill, John D. |
| Publisher | Curtin University of Technology, Australian Telecommunications Research Institute. |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | unrestricted |
Page generated in 0.0105 seconds